Bedienungsanleitung Life Fitness E1 (Seite 25 von 32) (Englisch)

655174

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

8 sErvicE and product maintEnancE

8.1 TROUBLESHOOTING

PROBLEM CAUSE / SOLUTION

No power.

Check to see that the power cord is fully plugged into the back of the Total-Body Elliptical

Cross-Trainer and into the wall. Make sure the power cord is fully seated into the back of

the Total-Body Elliptical Cross-Trainer.

You may be in “Energy Saver Mode”. Press the “Energy Saver” button to see if the con-

sole turns on.

Verify that all customer assembly connections are working properly. Unplug and re-plug

each connection to verify. Look to see if any cables were pinched during assembly.

Total Body Arms feel

loose.

Remove the moving arm pivot covers and check to make certain the bolt holding the total

body arm in place is fully tightened. If the total body arms still feel loose, you may want to

disassemble the total body arms and make sure all of the proper hardware from the as-

sembly instructions was used.

Noise is coming from

pedals.

Some noise from the pedals is normal. It will vary depending on the weight of the user.

Check assembly hardware beneath pedal to make certain it is tight.

Hear noise as speed

increases

It is normal for any mechanical device to become louder as speed increases.

Start-Up resistance

seems very difcult.

Your product may be in ‘Safety Mode.’ Refer to the console manual on how to turn off this

setting.

Turn the unit off and then on again.

Can’t feel a resistance

change at the beginning

levels.

The resistance curve of the Total-Body Elliptical Cross-Trainer is designed

so that you can feel a greater difference in resistance at higher levels.

Wireless heart rate is not

working.

Potential reasons for the wireless heart rate not to work properly include:

1. The wireless heart rate is turned OFF in the Settings Menu. Enter the Settings Menu

and verify that WIRELESS HR is turned ON.

2. There is poor contact between the telemetry heart rate strap and the skin.

3. There is electrical interference from electrical appliances with the telemetry heart

rate strap from uorescent lights, kitchen appliances, etc. Move the T

otal-Body Elliptical

Cross-Trainer to a different location or move electrical appliances away from the Total-

Body Elliptical Cross-Trainer.

4. The battery in the Heart Rate Telemetry Strap needs to be replaced. The battery is a

CR2032 (3V).

Creaking sound is com-

ing from the stabilizers.

It is very important that the nut on the leveler is tightened against the

stabilizer tube after the product is leveled. Ensure that this nut is tight.

“OFF” is displayed in the

LEVEL window on the

console.

Turn the unit off and then on again.

If power cycling the product did not work, there is a problem with the resistance system.

Contact Customer Support Services for assistance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Life Fitness E1 Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Life Fitness E1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info