Bedienungsanleitung Liftmaster 520 (Seite 1 von 2) (Englisch)

536966

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Universal Radio Control

OWNERS MANUAL

Transformer Model 85 may be required if your

garage door opener is a brand other than Lift-Master,

Chamberlain or Sears.

NOTE: Models 520-1LM and 520-2LM are factory pre-

set with matching receiver and remote control

codes. If you purchase additional remote controls,

the receiver may be programmed to match the new

remote control code (up to 4 “smart” remotes and

one Keyless Entry Transmitter).

THE RECEIVER MAY BE INSTALLED IN ONE OF TWO

WAYS:

1. Mounted directly on the door opener with clips

provided as shown on page one.

2. Attached to an inside wall of the garage with connecting

bell wire (not supplied) as shown on page two.

When installing two or more receivers in a garage,

position them at least 10 feet apart to prevent electronic

interference.

MOUNTING RECEIVER ON A COMMERCIAL OPENER

Fully extend antenna wire below bottom of case as shown.

Loosen the three terminal screws on the receiver

(labeled 1, 2 and 3). Insert one end of a mounting clip

under each terminal. Make sure the clips are positioned

to clear the receiver flange, as shown.

Do not retighten

at this time.

Loosen the three terminal screws on the opener used for

push button controls and radio power.

Leaving the push button bell wire in place, insert the

other ends of the mounting clips under the opener

terminal screws.

NOTE: If the number sequence of opener terminals

doesn't match the receiver, turn the receiver around

(so back is facing out) and complete the connection.

Retighten the terminal screws on opener and receiver.

Reconnect power to the opener. The receiver push bar

should light. If it does not, use Transformer Model 85.

MOUNTING ON RESIDENTIAL OPENERS

Use a 2 wire connection

only.

Attach mounting clips

to receiver terminals 1 and 2, and to the opener

terminals used for push button controls. Plug the

transformer into the receiver as shown, and into a

120 Volt outlet.

Model 520LM

Receiver Only

Model 520-1LM

(With 1 Remote Control)

Model 520-2LM

(With 2 Remote Controls)

Page two contains wall mounting instructions and

service information as well as code setting

instructions.

Children operating or playing with a garage door

opener can injure themselves and others.

The

garage door could close and cause serious injury

or death.

Do not allow children to operate the

push buttons or the remote control transmitters.

Install the receiver (and any additional push

buttons) out of the reach of children and away

from all moving parts of the door and door

hardware, but

where the garage door is visible.

A moving garage door could injure someone

under it.

Activate the opener only when the door

is properly adjusted, you can see it clearly, and

there are no obstructions to door travel.

WARNING

Disconnect power to the garage door opener

before installing the receiver.

WARNING

To Outlet

Model 85

Transformer

OPENER

TERMINALS

Receiver

Terminals

Antenna Wire Fully Extended

Flange

Mounting

Clip #1

Mounting

Clip #2

Mounting

Clip #3

Common

Push Button

Radio Power

To comply with FCC/IC rules, adjustment or modification of receiver and/or

transmitter is prohibited, except for changing the code setting and replacing

the transmitter battery. THERE ARE NO USER SERVICEABLE PARTS.

NOTICE TO U. S. CONSUMERS:

Some states prohibit the service or repair of garage door

openers whch cannot be made to comply with the safety

standards contained in UL 325 (1988 revision). In order to

comply with both the letter and the spirit of these laws, this

universal radio control should not be used with any Lift-Master

Chamberlain

, or Sears Craftsman

garage door opener

manufactured prior to April 1, 1982. To find out if your

Chamberlain-made garage door opener was manufactured prior

to or after April 1, 1982, please call 1-800-528-9131 before

installing this universal radio control.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liftmaster 520 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info