Bedienungsanleitung Linksys SRW2008 (Seite 59 von 81) (Englisch)

602174

Zoom out

Zoom in

Vorherige Seite

1/81

Nächste Seite

Chapter 5

Advanced Configuration

8-Port 10/100/1000 Gigabit Switch with Webview

all error reporting. For example, Syslog and local device

reporting messages are assigned a severity code, and

include a message mnemonic, which identifies the source

application generating the message. It allows messages

to be filtered based on their urgency or relevancy. Each

message severity determines the set of event logging

devices that are sent per each event logging.

Logging Indicates if device global logs for Cache, File,

and Server Logs are enabled. Console logs are enabled by

default.

Emergency • The system is not functioning.

Alert • The system needs immediate attention.

Critical • The system is in a critical state.

Error • A system error has occurred.

Warning • A system warning has occurred.

Notice • The system is functioning properly, but system

notice has occurred.

Informational • Provides device information.

Debug • Provides detailed information about the

log. If a Debug error occurs, contact Customer Tech

Support.

Admin > Port Mirroring

Port mirroring monitors and mirrors network traffic by

forwarding copies of incoming and outgoing packets

from one port to a monitoring port. Port mirroring can be

used as diagnostic tool and/or a debugging feature. Port

mirroring also enables switch performance monitoring.

Network administrators configure port mirroring by

selecting a specific port to copy all packets, and different

ports from which the packets are copied.

Source Port Defines the port to which traffic is mirrored.

Type Indicates the port mode configuration for port

mirroring. The possible field values are:

RxOnly • Defines the port mirroring on receiving ports.

This is the default value.

TxOnly • Defines the port mirroring on transmitting

ports.

Both Defines the port mirroring on both receiving and

transmitting ports.

Target Port Defines the port from which traffic is

mirrored.

Admin > Cable Test

The Cable Test screen shows you results from performance

tests on copper cables. The maximum cable length that

can be tested is 120 meters. Cables are tested when the

ports are in the down state, except for the Approximate

Cable Length test.

Admin > Cable Test

Port This is the port to which the cable is connected.

Test Result This is the test result. OK indicates that the

cable passed the test. No Cable means there is no cable

connected to the port. Open Cable means the cable is

connected on only one side. Short Cable indicates that a

short has occurred in the cable. Undefined indicates that

the test could not be properly performed.

Cable Fault Distance This is the distance from the port at

which the cable error occurred.

Last Update This is the last time the port was tested.

Test Click the Test button to perform the test.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Linksys SRW2008 Seite 59

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info