Bedienungsanleitung Linksys WRT150N - Wireless-N home router (Seite 10 von 90) (Englisch)

495211

Zoom out

Zoom in

Vorherige Seite

1/90

Nächste Seite

Chapter 2: Planning Your Wireless Network

Network Topology

Wireless-N Home Router

Chapter 2: Planning Your Wireless Network

Network Topology

A wireless local area network (WLAN) is exactly like a regular local area network (LAN), except that each

computer in the WLAN uses a wireless device to connect to the network. Computers in a WLAN share the same

frequency channel and SSID, which is an identification name shared by the wireless devices belonging to the

same wireless network.

Ad-Hoc versus Infrastructure Mode

Unlike wired networks, wireless networks have two different modes in which they may be set up: infrastructure

and ad-hoc. An infrastructure configuration is a WLAN and wired LAN communicating to each other through an

access point. An ad-hoc configuration is wireless-equipped computers communicating directly with each other.

Choosing between these two modes depends on whether or not the wireless network needs to share data or

peripherals with a wired network or not.

If the computers on the wireless network need to be accessible by a wired network or need to share a peripheral,

such as a printer, with the wired network computers, the wireless network should be set up in Infrastructure

mode. The basis of Infrastructure mode centers around a wireless router or an access point, such as the

Wireless-N Home Router, which serves as the main point of communications in a wireless network. The Router

transmits data to PCs equipped with wireless network adapters, which can roam within a certain radial range of

the Router. You can arrange the Router and multiple access points to work in succession to extend the roaming

range, and you can set up your wireless network to communicate with your Ethernet hardware as well.

If the wireless network is relatively small and needs to share resources only with the other computers on the

wireless network, then the Ad-Hoc mode can be used. Ad-Hoc mode allows computers equipped with wireless

transmitters and receivers to communicate directly with each other, eliminating the need for a wireless router or

access point. The drawback of this mode is that in Ad-Hoc mode, wireless-equipped computers are not able to

communicate with computers on a wired network. And, of course, communication between the wireless-

equipped computers is limited by the distance and interference directly between them.

Network Layout

The Wireless-N Home Router has been specifically designed for use with your Wireless-N, Wireless-G, and

Wireless-B products. It will work with notebook adapters for your laptop computers, PCI adapters for your

infrastructure: a wireless network that is bridged

to a wired network via an access point.

ssid (service set identifier): your wireless network’s name.

ad-hoc: a group of wireless devices

communicating directly to each other (peer-to-

peer) without the use of an access point.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Linksys WRT150N - Wireless-N home router Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Linksys WRT150N - Wireless-N home router

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info