Bedienungsanleitung Linksys WRT54 (Seite 64 von 81) (Englisch)

97358

Zoom out

Zoom in

Vorherige Seite

1/81

Nächste Seite

Appendix B: Wireless Security

Maximizing Wireless Security

Wireless-G Broadband Router

The solution, then, is to segment your network up into multiple groups. If your network had 80 users and you

used four WEP keys, a hacker would have access to only ¼ of your wireless network resources. In this way,

multiple keys reduce your liability.

Finally, be sure to change your WEP key regularly, once a week or once a day. Using a “dynamic” WEP key, rather

than one that is static, makes it even harder for a hacker to break into your network and steal your resources.

WEP Encryption

WEP encryption for the Router is configured through the Web-Utility's Security tab. Select WEP from the drop-

down menu of Security Mode, which will open the WEP screen, shown in Figure B-2.

Select which WEP key (1-4) will be used when the Router sends data, then select that number as the Default

Transmit Key. Make sure the receiving device is using the same key.

If you wish to use a WEP Passphrase, it can be a maximum of 16 alphanumeric characters. This passphrase may

not work with non-Linksys products due to possible incompatibility with other vendors' passphrase generators.

The WEP Key can be generated using your Passphrase or you can enter it manually.

If you wish to enter the WEP Key manually, type the key into the appropriate Key field on the left. The WEP key

must consist of the letters “A” through “F” and the numbers “0” through “9” and should be 10 characters in

length for 64-bit encryption or 26 characters in length for 128-bit encryption. All points in your wireless network

must use the same WEP key to utilize WEP encryption.

Once the Passphrase is entered, click the Generate key to generate a WEP key.

Click the Save Settings button to apply your changes and return to the Setup tab or Cancel Changes to cancel

your changes.

C. WPA

Wi-Fi Protected Access (WPA) is the newest and best available standard in Wi-Fi security. Two modes are

available: Pre-Shared Key and RADIUS. Pre-Shared Key gives you a choice of two encryption methods: TKIP

(Temporal Key Integrity Protocol), which utilizes a stronger encryption method and incorporates Message

Integrity Code (MIC) to provide protection against hackers, and AES (Advanced Encryption System), which utilizes

a symmetric 128-Bit block data encryption. RADIUS (Remote Authentication Dial-In User Service) utilizes a

RADIUS server for authentication and the use of dynamic TKIP, AES, or WEP.

WPA is accessed through the Web-Utility's Security Tab. Choose one of the following Security Modes from the

drop-down menu:

Figure B-2: WEP

Important: Always remember that each

point in your wireless network MUST use the

same WEP Encryption method and encryption

key or your wireless network will not function

properly.

Figure B-3: Pre-Shared Key

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Linksys WRT54 Seite 64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Linksys WRT54

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info