IX. Basic Commands
1. Intensity – Vibration and Electrical Impulse Manual Settings
1. Use the ∧ and ∨ to choose the intensity symbol.
2. Press the > and < buttons in order to increase the intensity on
the vibration (3 levels of intensity) or the electrical impulse
3. Both Electrical impulse and Vibration can be used manually
with with Intensity button, or on specified modes with their
individual mode settings. See section 3 for vibration
and section 4 for electric pulse modes.
★ IMPORTANT:
Always use caution when increasing the electrical impulse feature. The
intensity can be increased up to level 16. It is recommended that new
users to start at 1 and test in increments of one until a comfortable level
is reached. Such levels are generally between 5 and 6.
★ Please note that to rapidly lower intervals the remote needs to be pointing at the
infrared emission window (see Figure 4) and will beep with each change and will
take a few seconds for each change to be accomplished.
2. Increasing and Decreasing Heat
1. Use the ∧ and ∨ to choose the heat symbol.
2. Press the > and < in order to increase the heat to high (H),
low (L) or none (0).
3. Selecting Vibration Modes
1. Use the ∧ and ∨ to choose the vibration symbol.
2. Press the > and < in order to select between the 6 vibration
modes:
1. Auto-vibration
2. Vibration only
3. Knead
4. Beating
5. Press
6. Rolling
4. Electric Impulse Modes
1. Use the ∧ and ∨ to choose the electrical impulse symbol.
2. Press the > and < in order to select between the 6 impulse
modes.
.
5. Timer
1. Use the ∧ and ∨ to choose the timer symbol.
2. Press the > and < in order to set the timer within 5
minute intervals.
★ It is not recommended using the neck massager for longer than 15
minutes at a time.
X. Troubleshooting
★ IMPORTANT:
Always use caution when increasing the electrical impulse feature. The
intensity can be increased up to level 16. It is recommended that new
users to start at 1 and test in increments of one until a comfortable level
is reached. Such levels are generally between 5 and 6.
★ Please note that to rapidly lower intervals the remote needs to be pointing at
the infrared emission window (see Figure 4) and will beep with each change and
will take a few seconds for each change to be accomplished.
Problem Potential Solution
Neck massager
does not turn on
Leave neck massager on charger for
at lease 3-4 hours
Neck massager will
not switch modes
or switches to
rapidly.
Allow 15 seconds after increasing/
decreasing intensity or changing
mode in order to feel the change in
intensity.
Neck massager will
not connect with
remote
See Figure 4. Check that infrared
emitting window on remote is close
to infrared receiving window on neck
piece.
