13 2
NOTE: Set up as close to power source as possible. The product
should be periodically examined for potentially unsafe conditions
such as: damaged cord, plug, housing or parts, and that in the
event such damage is found, the product should not be used until
properly repaired. Never leave the blower outside in the rain or
exposed to the elements when not in use. When in use, do not
place the cord across trac areas, water or damp areas. The
blower should be placed on a stable surface and anchored per
product instructions. The power cord of the blower is equipped
with a Ground Faulty Circuit Interrupter (GFCI) plug.
1) Make sure that the blower switch is in the “OFF” position. Plug
the blower into a properly grounded 110-120V GFCI outlet.
2) If the GFCI has been tripped, press the “RESET” button to
restore power to the blower.
3) Set the power switch of the blower to “ON” to inflate. After use,
turn the power to “OFF.”
4) To disconnect, have an adult grip it tightly and pull the plug
from wall outlet.
MODEL RW-2LA
BLOWER SPECIFICA
60 Hz, 4.8A, 552W
GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS
This product should
providing an escape
propriate
all local codes
If repair or at blade terminal. The
wire with Grounding wire.
Qualied electrician or serviceman if the grounding
The product is plug provided; if it t the outlet, have the proper outlet
by a
nominal 110-120-volt
volt supply circuit, and has a grounding
be used. Do not use product until a properly grounded outlet (sketch A) can be installed by a quali
CAUTION: The blower is a high volume blower, and is capable of moving lots of air very quickly. Place the blower in
an area where it will not suck in dirt or leaves. Keep away from water and trafc. Keep children away from the blower.
Only the blower supplied should be used for ination
S
This blower is not a toy
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
GROUNDING METHODS
Grounding
pin
D
INSTRUCTIONS FOR BLOWER CLEANING AND STORAGE
Do not immerse the blower in water. Unplug the blower before cleaning. To clean: wipe with a damp cloth. The blower does not require
any lubrication and has no user serviceable parts. Do not attempt to service the blower. When not in use, store the blower indoors in a
dry place. Store the blower upright on a stable surface. Loosely coil the cord and place it beside the blower.
INSTRUCTIONS FOR BLOWER INSTALLATION
USE ONLY ON GFCI PROTECTED RECEPTACLES CAUTION
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESUL
AND SUPERVISION REQUIRED.
DANGER - TO PREVENT ELECTRIC SHOCK, DO NOT IMMERSE
IN WA.
result in serious injury or death.
W
Electrocution Hazard- DO NOT USE
EXTENSION CORDS WITH THIS PRODUCT.
• Cautionary statements should be read before beginning assembly.
• ADULT SET-UP AND SUPERVISION REQUIRED.
• Use only with Ground Fault Circuit Interrupt (GFCI) receptacle.
• This blower is for residential use only. It is not intended to be used in commercial or
industrial settings.
• Never insert fingers, pencils or any other object through the grill at ANY time.
• Do not operate blower with a damaged cord or plug, after the appliance malfunctions
or has been dropped or damaged in any manner.
• Do not operate in the presence of explosive and/or flammable fumes.
• Never connect the blower to any solid - state speed control device.
• To reduce the risk of fire or electric shock, do not use this blower with any solid-state
speed control device.
• WARNING - Electronic hazard - Do not use extension cords with this product.
• Outdoor use only.
• Change the water of the pool frequently (particularly in hot weather) or when
noticeably contaminated.
• Children can drown in very small amounts of water. Empty the pool when not in use.
Do not install the pool over concrete, asphalt or any other hard surface.
CAUTION: ELEC
OPERA
LISTED
E230679
Storage
23
Fold all pieces of the waterpark (i.e. Slide,
Air Inlet Tube, etc.) toward the center.
NOTE: If bottom surface is still moist, allow it to air
dry prior to folding.
Roll up the waterpark
tightly and compress the
fabric to expel all of the
remaining air.
NOTE: Do not place the
Water Spray Tubing
inside the waterpark
when rolling it up.
Repair Patch Instruc WARNING: NOT A TOY. ADULT USE ONLY.
Repair Patch . Keep awa y fr
1
2
WARNING: Repair patches must be applied by an adult only. KEEP OUT OF REACH OF CHILDREN.
REP
1. Deate the item, clean the area and allow to dry thoroughly
2. Cut a portion of the patch to the size needed and round the corners. (See Fig. 1 & 2).
3. Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any bubbles.
4. Allow to sit for 30 minutes before re-inflating.
1
Instructions for
Bouncer Maintenance
Instructions for
Blower Maintenance
• As
deterioration. Inspect for signs of fabric failure; weak or torn
surfaces must be repaired promptly.
• To
cloth or a cloth dampened with a neutral, non-ammable, non-
• Product
Disposal
• Disassemble and dispose of the equipment in such a manner that no hazardous
conditions exist at the time the equipment is discarded.
• Blower should be returned to a collection center capable of
processing electrical/electronic waste.
• Blower must be
• Product should be
damaged cord, plug, housing, or parts, and that in the even such damage is found,
the product should not be used until properly repaired. If these checks are not carried
out, the product could overturn
•
attempt to service the blower.
• Do not immerse
• Regularly check the
• When not in
• Store the blower
• Loosely coil the
• When in use,
• The blower is
very quickly. Place the blower
• Do not operate
authorized service facility for examination
• Do not run
similar coverings. Do not route
away from trac area and where it will not be tripped over.
