Bedienungsanleitung Livin Flame Berlijn (Seite 9 von 24) (Deutsch, Englisch, Französisch)

742164

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Getting started

- Remove the appliance from the box.

- Remove any packaging from the product.

- Place the packaging inside the box and either store or dispose of safely.

Contents of Carton

- Electric wall mount replace

- Wall xing bracket

- Fixing screws and wall plugs

- Remote control

- Instruction Manual

- Pebbles

Helpful Advice Before Fitting

- Please retain all packaging until you have checked and counted all the parts and the contents of

the xing pack against the parts list.

- Do not use this appliance if any part has been under water. Immediately call a qualied

service technician to inspect and to replace any part of the electrical system if necessary.

- Keep little children away before and during installation. Be aware that the little children do not

be in contact with the parts.

- The electric replace can be installed almost anywhere in your home. Please, read and follow the

instructions carefully by choosing a location. For the best result, install the electric replace not in

direct sunlight.

Tools required

- Magnetic Phillips Screw Driver

- Rotary hammer

Installation

- It’s recommended at least 2 or more people install the replace.

- Do not switch the appliance on until it properly installed as described in this manual.

- Please note that before the electric replace will be installed on the wall, care must be taken not

to damage concealed cables.

- The electric replace should be located close to a suitable mains socket to enable connection. The

electrical socket must be easily accessible to allow disconnection.

- A height of 600mm from bottom of heater to oor is recommended for optimum viewing of

fuel bed.

- This appliance is designed to be permanently xed to a wall at a minimum height of 300mm. The

wall bracket must be tted horizontally and the cable routed to the bottom right of the heater.

- For optimum viewing, mark the top four screws xing positions on wall in accordance with the

recommend xing dimensions, see Picture 2. Drill holes with a screw driver.

- Fix the wall bracket using that the plug and screws provided.

- Carefully lift the heater up ensuring that the top rear ledge of heater engages the wall bracket

(see Picture 2 in circle) and is sitting centrally.

- Gently bring the heater level with the wall.

- Mark the bottom holes position, see Picture 3, remove the heater ensuring that the bottom

xing bracket is rotated up.

- Drill and t wall plug.

- Ret the heater to the wall xing bracket and rotate the bottom xing bracket down again and use

the screw provided to permanently x the heater in place.

- Unpack the pebbles from the bag and place them along the light unit in the desired position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Livin Flame Berlijn Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info