26
Q: I have configured the Wi-Fi module, but it does not connect itself to the network and the green
and red LED lights are blinking.
A:
•
Check if the network data used are correct.
•
Try to move the module closer to the router.
•
Disconnect the module from the stove, wait a few seconds and reconnect it.
•
See the table at section 6.12, which shows the functionality based on the LED status.
Q: After the configuration of the DPRemote application, it shows me the following error:
A: Go to the settings (see section 7). Check if the (right) Device Code is entered and the check-box
next to the appliance is selected.
Q: After the configuration of the DPRemote application, it shows me the following error:
A: Check if the module has the green LED light on solid and if the red LED light is OFF.
Check if the smartphone that you are using, is connected to the internet.
Check if you have inserted the correct “Device Code”.
Q: I can’t find an answer in these FAQ’s.
A: Try to disconnect the module from the stove, wait a few seconds, reconnect it to the stove and
repeat the configuration of the module and/or the application.