Bedienungsanleitung Livin Flame Leeds (Seite 18 von 24) (Deutsch, Englisch, Holländisch, Französisch)

742166

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

ENG-6

Maintenance

Warning: Before any maintenance and/or cleaning the exterior of the replace, disconnect the unit from

the power supply and leave until cooled off.

Remote Handset Battery Replacement: Replace with two AAA batteries. Make sure the batteries are

installed correctly in the remote control.

Maintenance of Motors: The motors used on the fan and ame effect are pre-lubricated for extended

bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater unit

is recommended.

Resetting the Thermal Cutout Switch: The appliance is tted with an Electronic Safety Control (E.S.). This is

a safety device, which switches off the re if, for any reason, the appliance overheats, e.g. when covered. If

the heater stops operating whilst the ame effect continues normally, this indicates that the E.S. Control is

in operation. The E.S. Control can only be re-set after the appliance has cooled down, in order to re-set the

E.S. Control proceed as follows:

- Switch off the appliance (Manual On/Off switch) and leave for approximately 10-15 minutes.

- Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that the power

supply is disconnected at the plug socket outlet whilst you do this.

- Switch on appliance and the E.S. Control will re-set.

- Ensure that the appliance is functioning correctly.

Cleaning the replace

You can clean the exterior of the replace with a soft, damp, lint-free cloth. Do not use cleaning or

polishing products. To remove ngerprints or other remarks on the front glass panel, use a soft, damp,

lint-free cloth with a good quality household glass cleaner. The front glass panel should always be

completely dried with a clean, lint-free cloth or paper towel.

Caution: Do not use abrasive cleaners on the glass panel. Do not spray liquids directly onto any surface of

the unit.

Warning: An authorized service representative should perform any other servicing.

Warranty

Your replace has two year warranty against manufacturing defect, beginning at the date of purchase.

In case of a problem, contact the store that it sold to you.

Warranty will be honored when you present a dated invoice and is strictly limited to recognized faulty part.

Installation costs cannot, under any circumstance, be reimbursed for damages.

The manufacturer can’t be held responsible for direct or indirect defect consequences, either towards

person or property.

The warranty will be voided if the replace was misused or used for other purpose than what they were

built for. The warranty will also be voided in case of deterioration or accident that occur following neglect,

bad supervision or form altered parts.

Technical specications

Voltage: 220V-240V~ 50Hz

Total Watts: 2000W

Dimensions: 640mm L x 155mm W x 560mm H

Weight: 8 kg

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Livin Flame Leeds Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info