Bedienungsanleitung Loewe Art 60 - SL2 (Seite 4 von 44) (Englisch)

645606

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Connect ID 40-55 - 4 -

Quick guide

english

For your safety, and to avoid unnecessary damage to your unit,

please read and follow the safety instructions below:

Intended use and ambient conditions

This TV set is intended exclusively for receiving and playing visual and

audio signals. It must not be used in rooms with a high level of humi-

dity (e.g. bathroom, sauna) or a high dust concentration. The

manufacturer‘s warranty is only valid for use in the specified permis-

sible environment.

If the unit is used outdoors, make sure that it is protected from moisture

(rain, dripping water and splashing water or dew). High humidity and

dust concentrations lead to leakage currents in the device. This can

result in a shock hazard when touching it or even fire.

If you have moved the unit out of

the cold into a warm environment,

leave it switched off for about an

hour to avoid the formation of

condensation.

Do not place objects containing

liquids on top of the unit. Protect

the appliance against dripping and

splashing water.

Candles or naked flames must be

kept away from the TV set at all

times to prevent it from catching

fire.

Never place the TV set in a location where it is exposed to vibrations.

This may lead to damage.

Transporting

Move the device in vertical position only. Get hold of the device on

the upper and lower edges of the housing.

If the set has to be put down during packing/unpacking, place the TV

set with its entire front surface lying flat on soft material. Use a blanket

or the fleece from the packing material as an underlay.

The LCD screen is made of glass or plastic and can break if not handled

properly.

Always wear rubber gloves to carry the TV set if the LCD screen is

damaged and liquid crystal might be leaking out. In the case of skin

contact immediately rinse thoroughly with water.

Power supply

Incorrect voltages can damage the unit. This device may only be con-

nected to a power supply with the voltage and frequency indicated on the

type plate using the supplied mains cable. The mains plug of the TV set

must be easily accessible so that the device can be disconnected from

the mains at any time. When unplugging the unit from the mains, pull at

the connector body and not at the cable. The cables in the mains plug

could otherwise be damaged and could cause a short-circuit when

plugged in again.

Lay the mains cable so that it cannot be damaged. Do not step on

the mains cable. The mains cable may not be kinked or laid over sharp

edges nor be exposed to chemicals; the latter also applies to the unit

as a whole. A mains cable with damaged insulation can cause electric

shocks and poses a fire risk.

Air circulation and high temperatures

The vent slots on the rear panel of the set must always be kept

unobstructed. Please do not place newspapers or cloths on/over the

TV set.

Make sure that there is at

least 10 cm free space on the

sides and above the set for

air circulation, if the set is

placed in a cabinet or on a

shelf.

Like any electronic device,

your TV set requires air for

cooling. Obstruction of the

air circulation can cause fires.

Prevent metal items, needles, paper clips, liquids, wax, or similar

items, from getting into the interior of the device through the vent

slots in the rear panel. Such objects can cause short circuits in the

set, which could possibly cause a fire.

If something should get into the interior of the set then immedi-

ately unplug the mains plug of the device and contact the field service

for more information.

Set-up

The set is suitable for mounting in many different ways. Note the as-

sembly instructions regarding the different possible mounting options.

Before setting up the device, please check that the final location is

suitable to bear the load of the device in terms of surface (sensitivity

to pressure) and stability (statics).

This is particularly the case for the high-gloss painted surfaces and

surfaces that are made from real wood/real wood veneer.

Place the TV set with the table or floor stand only on a level, sturdy,

horizontal base. Particularly make sure that the set does not protrude

to the front when placed in or on pieces of furniture.

Place the TV set in a normal position for use. The TV set may only be

used in an upright horizontal position. It may not be tilted by more

than 10 degrees. The TV set must never be operated in portrait posi-

tion, lying flat or hanging overhead from the ceiling.

Set up the device where it is not exposed to direct insolation and

where it is not exposed to additional heating by radiators.

About the LCD screen

The TV set with LCD screen you have purchased satisfies the most

rigorous quality requirements and has been inspected with respect

to pixel errors. Despite of thorough care when manufacturing the

display, it cannot be 100% guaranteed that no subpixel defects will

occur due to technical reasons. Please understand that these types

of effects, as long as they are within the limits specified in the standard,

cannot be considered as a device defect in terms of the guarantee.

Avoid displaying still images for long periods of time. It is possible that

a copy of the image may remain visible.

10 cm

±10°



For your safety

Loewe Art 60 - SL2 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Loewe Art 60 - SL2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info