Bedienungsanleitung Loewe Connect 32 Media Full-HD+ (Seite 13 von 78) (Englisch)

65312

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

13 -

In various countries, digital stations (DVB-T, DVB-C) are

transmitted with a preset channel number per station,

known as “Logical Channel Numbers“ – “LCN“. In this

case the preset channel numbers are adopted as station

memory locations and the stations of the preferred signal

source sorted according to LCN. There may be gaps in the

numbering of the station list depending on the LCN.

For TV sets with MHEG-5 software the stations are tied

to “Logical Channel Numbers” – “LCN” and sorted from

1-799. Digital stations without “LCN” are stored from

800 onwards. Analogue stations are stored from 1001.

If you are using an active antenna, then select yes (5V)

for the antenna power supply.

The conventional settings will be derived from the selec-

tion of set location. Only change this if you know other

symbol rates and modulation types or if you have to spec-

ify the network ID for your cable network (information

available from your cable network provider). If you want

to run the station search independently of the channel

grid, select frequency search for the search method.

State how (single satellite or type of satellite system) you

receive which satellite(s). Ask your dealer if in doubt.

Specify here whether the high band of the selected satel-

lite is to be searched in addition to the low band.

Normally, you do not need to change the values for high

and low band, unless the LNC (LNB) of your satellite

system uses a different oscillator frequency (important

for the frequency display).

After you have made these settings, you should receive

the picture and sound of the selected satellites (only with

Astra1 and HOTBIRD).

If you want to run the station search independently of

the channel grid, select frequency search for the search

method.

The symbol rates are specified by the satellite provider

and do not normally need to be changed.

Select the signal source from a list, the station of which is

to be at the top of your station list (starting with station

slot 1).

Recordings with automatic time control (see page 54) are

only possible for the respective first DVB signal source.

Initial installation

Explanations of the setting possibilities, including the upgradeable

satellite reception:

Decide how energy efficiently you want to operate your

TV set. The value for the contrast (and thus the brightness

of the background lighting) is adapted and the automatic

dimmer activated or deactivated (see page 22) depending

on the presetting.

Eco standard:

The emphasis for home use is on low energy consump-

tion. The automatic dimmer is activated.

Premium mode:

This mode optimises the settings to a brighter environ-

ment at a higher energy consumption. The automatic

dimmer is activated.

Shop mode:

The picture settings are aligned to operation in the presen-

tation room. The automatic dimmer is deactivated. If the

ambient brightness diminishes, the energy consumption

is not reduced.

The presetting can be changed later in the TV menu under

Picture  Picture adjustment  Presettings (see page 22)

or under Settings Energy efficiency.

Select the country for country-specific pre-settings.

If UK or IRL is selected for the location of TV set, it is

possible to activate MHEG-5 (UK Freeview) for the TV set.

A dialogue appears, where you can confirm to set the

operating software to the selected location.

If Yes is selected and confirmed with OK, the TV set turns

off and on again automatically. First installation starts

again after activating the operation software.

If MHEG-5 was activated, DVB-C and DVB-S can not be

used anymore. Only terrestrial/cable and DVB-T stations

are available.

Antenna/cable (analogue):

analogue stations via

cable/antenna

DVB-T: digital terrestrial stations

DVB-C: digital stations via cable

DVB-S (cable 1): digital stations via satellite

DVB-S (cable 2): digital stations via satellite

You can state whether coded stations are to be searched

for in the search/update.

Select yes to save all found

scrambled stations. However, these stations can only

be received in connection with a CA module and the

appropriate Smart Card.

Handling of the CA module is

described on page 40.

If a CA module with a SmartCard is already plugged in for

the station search, all the stations which this module can

descramble are also saved when no is preset.

Logical

Channel

Number

DVB-T:

Antenna

DVB-C:

Settings

DVB-S:

Satellite

system

High band

LNC

frequencies

Low Band /

High Band

method

Symbol rates

Favoured

signal source

Energy

efficiency

Location of

TV set

Antenna

selection

Encrypted

stations

continued on next page

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Loewe Connect 32 Media Full-HD+ Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Loewe Connect 32 Media Full-HD+

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info