Bedienungsanleitung Loewe DVB-T-S (Seite 12 von 49) (Englisch, Französisch, Spanisch)

475074

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

Daily handling

Playing radio stations

Change to radio mode with RADIO in order to play radio stations

(Exception: During active timer recording).

Call up the station table by pressing the OK button. You can then call, sort

and rename radio stations etc. exactly the same as for TV stations.

Press RADIO again to change back to TV mode.

END

Radio mode: 5 B5 AKTL

AUDIO IN

AVS

AV2

AV1

1 B5 AKTL

2 BAYERN 1

3 BR4 KLSK

4 SUNSHINE

5 ROCK ANT

6 ANTENNE

7 DLR

8 DLF

9 HR-INFO

10 MDR INFO

11 MDR FIGA

12 NDR KULT

13 SWR1

14 SWR2

15 WDR3

16 WDR5

17 OESTER 1

18 MDR JUMP

19 JAZZ RAD

20 BLUSAT20

Switch over Scan sations

Select station Previous channel

Screen off Change sorting

0 9

...



You can play the radio stations for a few seconds from the selected entry

upwards using the green button ”Play stations”. Pressing the green

button again stops the play.

You can switch off the screen in order to save energy using the red button.

Pressing the red button again or OK

switches the screen on again.

Removing the CI module

1. Switch off your TV at the power switch.

2. Press in the eject button on the slide-in module, the module jumps out.

3. Pull the module out of the set.

Calling the CI module menu

Here you can call information about the plugged Common-Interface

module and Smartcard. To do this, call the TV menu, select the ”Settings”

line and then the item ”CI-Module I/II – xxx”.

The content of this menu depends on the respective CI module provider.

Note:

This menu is only available with digital programs.

New CI module plugged

After plugging a new CI module and switching on the TV set, the

following dialog box appears:

END

Autom. channel search

Your TV set has detected a new CI module. This requires a

program search for all new receivable programs.

Continue with OK

After pressing the OK button, the wizard for the automatic station search

is started. Please check the suggested search parameters there.

Continue with the section ”Automatic station search” on page 8.

Digital audio output

You can also use the digital audio signals which your TV receives for

playing or recording the sound by an external audio system. The digital

sound output „DIGITAL (SPDIF) OUT“ (see fig. page 4) gives the sound

accompanying the television/radio programme.

Sound selection

If you are receiving a digital TV/radio programme with several sound

formats, you can call up the menu „Language/Sound selection“ by

pressing the END button. Press the green button after this.

If you have connected an external Dolby Digital decoder or the Loewe

AURO Preceiver and have entered this in the connection wizard, you

should now select „Dolby Digital“.

Note: The sound outputs of the TV set and speakers do not emit any sound

signals in this operating mode (Exception: the TV speakers are used as

active centre channel).

Only Stereo/PCM is reproduced with the setting ”Sound via TV”. This must

be considered when selecting the sound.

DVB_T_S_GB_F_Esp 18.11.2004, 13:51 Uhr12

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Loewe DVB-T-S Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Loewe DVB-T-S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info