Bedienungsanleitung Lorenz COMPACT X7 (Seite 2 von 152) (Englisch)

522471

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

4 User Manual

Warning!

Electronic charts displayed by the chart plotter are believed to be accurate and reliable, but they are not

intended to substitute for the official charts which should remain your main reference for all the matters

related to the execution of a safe navigation.

For this reason we would like to remind you that you are required to carry on board and use the officially

published and approved nautical charts.

Caution

 Please read through this manual before the first operation. If you have any questions, please contact the

Company customer service or your local dealer.

 The chart plotter is not built water proof. Please give attention to avoid water intrusion into the chart

plotter. Water damage is not covered by the warranty.

 Extensive exposure to heat may result in damage to the chart plotter.

 Connection to the power source with reversed polarity will damage the chartplotter severely. This damage

may not be covered by the warranty.

 The chart plotter contains dangerous high voltage circuits which only experienced technicians can handle.

 The C-MAP BY JEPPESEN C-CARD are available from your local dealer.

 We will not be liable for errors contained herein, or for incidental or consequential damages in connection

with the performance or use of this material.

 Exposure of display to UV rays may shorten life of the liquid crystals used in your chart plotter. This

limitation is due to the current technology of the LCD displays.

Avoid overheating which may cause loss of contrast and, in extreme cases, a darkening of the screen.

Problems which occur from overheating are reversible when temperature decreases.

Warning on Serial Ports Connection

Please be aware that the serial ports are not opto-isolated and then the external device is electrically connected to the

chart plotter. This allows the connection of high speed devices, like Fish Finder. If you are connecting a NMEA0183

device and you would like to isolate it from the chart plotter, you have to add the opto-isolator externally.

Cleaning procedure for the plotter screen

Cleaning of the plotter screen is a very important operation and must be done carefully. Since the surface is

covered by a antireflective coating, the procedure for cleaning all the surfaces can be performed using the

following procedure: You need a tissue or lens tissue and a cleaning spray containing Isopropanol (a normal

spray cleaner sold for the PC screen, for example PolaClear by Polaroid). Fold the tissue or lens tissue into a

triangular shape, moisten the tip and use the index finger behind a corner to move the tissue across the

surface, in overlapping side to side strokes. If the tissue is too wet, a noticeable wet film will be left in its path

and you will need to repeat the process. If too dry, the tissue won’t glide easily, and may damage the surface.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Lorenz COMPACT X7 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info