Bedienungsanleitung Lorus VD57 (Seite 2 von 2) (Englisch)

593802

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

■ NECESSARY PROCEDURE AFTER BATTERY

CHANGE

• When the battery is replaced, the time

information stored in the built-in IC and the

time indicated by the stopwatch hands do

not correspond with each other. Before

using the watch, therefore, be sure to reset

the hands to the “0” position, following the

procedure below.

* In case any of the hands should move

improperly, follow the procedure below to

adjust the hand movement.

1. Pull out the crown all the way.

2. Press and hold “A” and “B” at the same time

for 2 seconds, and then release the buttons.

* The stopwatch second hand turns half a

circle counterclockwise and then returns

where it was. The stopwatch 1/10-second

hand turns a full circle clockwise and stops.

3. Press “A” repeatedly to reset the stopwatch

1/10-second hand to the “0” position.

Press “B” repeatedly to reset the stopwatch

second and minute hands to the “0” position.

* The hands move quickly if the respective

buttons are kept pressed.

4. Turn the crown to set the hour and minute

hands to the desired time.

* For details, refer to “HOW TO SET THE TIME/

CALENDAR”.

5. Push the crown back into the normal position.

Stopwatch

minute

hand

Stopwatch 1/10-second hand

Crown

Second

click

Stopwatch

second hand

■ LUMIBRITE WATCH

✼ If your watch is a LORUS LUMIBRITE watch, it

has following features.

LORUS LUMIBRITE watches absorb and store light

energy from natural and artificial light sources

and emit light in the dark. They are made of

environmentally friendly material, and therefore,

are harmless to human beings and the

environment.

• With a full charge, LORUS LUMIBRITE watches

glow in the dark hours longer than conven-

tional luminous watches of this type. If ex-

posed to a light of more than 500 lux (i.e.,

the brightness of a typical office) for approxi-

mately 10 minutes, or direct sunlight for 2

minutes, they will glow for hours.

• Since LORUS LUMIBRITE watches emit the light

they store, the brightness will decrease

gradually over time. The length of time they

will glow may also differ slightly depending

on such factors as the brightness of and

distance from the light source used to charge

the watch.

■ CARE OF YOUR LORUS WATCH

• BATTERY

• WATER RESISTANT

* If your watch is 200 M/20 BAR, 100 M/10 BAR

or 50 M/5 BAR water resistant, it is so

indicated on the dial/case back.

• Do not press the buttons or turn the crown

when the watch is wet.

• If the watch is exposed to salt water, rinse it

in fresh water and then wipe it thoroughly

dry.

NO NO NO

YES

YES NO NO

YES YES NO

Condition

of use

Accidental

contact

with water,

such as

splashes

and rain

Swimming

and taking

a shower

Skin

diving

Scuba

diving

Indication

on the dial/

case back

Indication

YES

WATER

RESISTANT

WATER

RESISTANT*

(50M/5 BAR

)

WATER

RESISTANT*

100M/10 BAR

or above

(

Caution:

Leather straps are not water resistant except so

indicated, even if the watch head is water

resistant.

• ALLERGIC REACTION

Because the case and band touch the skin

directly, it is important to clean them regularly.

If not, shirt sleeves may be stained and those

with delicate skin may develop a rash. Please

wear the watch with some play to avoid any

possible allergic reaction. If you develop a rash

on your wrist, stop wearing and consult a

physician.

• MAGNETISM

Your watch will be adversely affected by strong

magnetism.Keep it away from close contact

with magnetic objects.

• SHOCKS AND VIBRATIONS

Your watch may be worn for normal sports

activities, but be careful not to drop it or hit it

on hard surfaces.

• TEMPERATURE

Your watch is preadjusted so that constant

accuracy may be insured at normal

temperature.

■ SERVICE

When your LORUS watch requires repair or

sevicing, please see the enclosed WARRANTY/

GUARANTEE.

CAUTION

Do not expose the old battery to fire

or recharge it. Keep it at a place

beyond the reach of children. If a

child swallows it, consult a doctor

immediately.

■ BATTERY CHANGE

The battery SEIKO SR920SW, Maxwell SR920SW,

SONY SR920SW, Matsushita SR920SW or

EVEREADY 371,which powers your watch, should

last approximately 2 years. However, because

it is inserted at the factory, the actual life of the

battery once in your possession may be less than

the specified period.

Be sure to replace the battery to prevent any

possible malfunction as soon as it runs down. To

replace the battery, we recommend taking the

watch to a local watch repair shop.

Note: If the stopwatch is used more than 60

minutes a day, the battery life may be

shorter than the above specified

period.

Start

* Measurement and

release of split time

can be repeated by

pressing button “B”.

Note: When “B” is pressed to reset the stopwatch

to “00”, the stopwatch second and minute

hands return to “0” position in 40 seconds.

Split time measurement

A A

BB B

Split

Release

Stop

Reset

Printed in China

Start Stop Restart Stop Reset

* Restart and stop of

stopwatch can be

repeated by pressing

button “A”.

Accumulated elapsed time measurement

A AA A

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Lorus VD57 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Lorus VD57

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info