Bedienungsanleitung Lorus Z009 (Seite 2 von 2) (Englisch)

593909

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

■

HOW TO USE TIMER

■

ENGAGEMENT/DISENGAGEMENT

OF ALARM & CHIME

1. Press Button D two times to go to the ALARM

mode.

2. With each press of Button B, the alarm and

chime can be engaged or disengaged in

the following order. The ALARM singal and/

or CHIME signal appear on the display

accordingly.

Both alarm and chime

are engaged.

Only alarm

is engaged.

Only chime

is engaged.

Neither alarm nor

chime is engaged.

Press Button D three times to go to the TIMER

mode. The TIMER mode indicator appears on

the display.

1. Press Button C to change the display to the

TIMER SETTING mode. The hour digits start

flashing.

2. Press Button B to set the hour digits. One digit

(flashing) is increased with each press of

Button B. The digits are increased quickly by

keeping Button B pressed.

3. Press Button D to confirm the hour setting and

move on to the minute setting. The minute

digits start flashing.

4. Press Button B to set the minute digits. One

digit (flashing) is increased with each press of

Button B. The digits are increased quickly by

keeping Button B pressed.

5. Press Button D to confirm the minute setting

and move on to the second setting. The

second digits start flashing.

6. Press Button B to set the second digits in the

same manner as the hour and minute setting.

7. Press Button C to complete the timer

setting.

3. Press Button D to return to the TIME/CALENDAR

mode.

Note: The alarm can be set only in one time zone.

How to stop the alarm while sounding

The alarm sounds for 10 seconds at the designated

time. To stop it manually while sounding, press any

Button.

TIMER OPERATION

1. Press Button B in the TIMER mode to start the

countdown timer.

2. Press Button B to stop the countdown timer.

3. To reset the timer, press Button C.

Press Button D to return to the TIME/CALENDAR

mode.

Start

Stop

Reset

Press Button D to return to the TIME/CALENDAR

mode.

The miniature battery either CR2016 or

CR2032, which powers your watch should last

approximately 2 years for CR2016 or 4 years for

CR2032. However, because it is inserted at the

factory, the actual life of the battery once in your

possession may be less than the specified period.

Be sure to replace the battery to prevent any

possible malfunction as soon as it runs down. To

replace the battery we recommend taking the

watch to a local watch repair shop.

Note: If the alarm is used for more than 20 seconds

a day and/or the illuminating light for more

than 8 seconds a day, the battery life may

be less than the specified period.

■

BATTERY CHANGE

■

HOW TO SET SECOND TIME ZONE

Press Button D four times to go to the SECOND TIME

ZONE. The SECOND TIME ZONE indicator appears

on the display.

1. Press Button C to change the display to the

TIME ZONE SETTING mode. The hour digits start

flashing.

2. Press Button B to set the hour digits. One digit

(flashing) is increased with each press of

Button B. The digits are increased quickly by

keeping Button B pressed.

3. Press Button D to confirm the hour setting and

move on to the minute setting. The minute

digits start flashing.

4. Press Button B to set the minute digits. The

minute digits are increased in 30-minute

increments.

5. Press Button C to complete the second time

zone setting.

■

HOW TO USE EL BACKLIGHT

In any mode press Button A to illuminate the

display for about 3 seconds.

Note:

1. The backlight of the watch employs an

electro-luminescent (EL) light, which tends to

lose illuminating power after very long use.

2. The illumination provided by backlight may be

hard to see when viewed under direct sunlight.

SECOND TIME ZONE

indicator

■

CARE OF YOUR LORUS WATCH

• BATTERY

CAUTION

Do not expose the old battery to ﬁre or

recharge it. Keep it at a place beyond

the reach of chil dren. If a child swallows

it, consult a doctor immediately.

• WATERRESISTANT

Condition

of use

Accidental

contact with

water, such

as splashes

and rain

Swimming

and taking

a shower

Skin

diving

Scuba

diving

Indication

on the dial/

case back

Indication

* If your watch is 200 M/20 BAR, 100 M/10 BAR

or 50 M/5 BAR water resistant, it is so indicated

on the dial/case back.

• Donotoperatethebuttonswhenthewatchis

wet.

• Ifthewatchisexposedtosaltwater,rinseitin

fresh water and then wipe it thoroughly dry.

NO NO NO

YES

YES NO NO

YES YES NO

YES

WATER

RESISTANT

WATER

RESISTANT

(50M/5 BAR

)

WATER

RESISTANT

100M/10 BAR

or above

(

Caution:

Leather straps are not water resistant except

so indicated, even if the watch head is water

resistant.

• ALLERGICREACTION

Because the case and band touch the skin

directly, it is important to clean them regularly. If

not, shirt sleeves may be stained and those with

delicate skin may develop a rash. Please wear

the watch with some play to avoid any possible

allergic reaction. If you develop a rash on your

wrist, stop wearing and consult a physician.

• MAGNETISM

Your watch will not be affected by magnetism

generated by household electric appliances.

• SHOCKSANDVIBRATIONS

Your watch may be worn for normal sports

activities, but be careful not to drop it or hit it on

hard surfaces.

• TEMPERATURE

Your watch is preadjusted so that constant

accuracy may be insured at normal tem pera ture.

■

SERVICE

When your LORUS watch requires repair or

sevicing, please see the enclosed WARRANTY/

GUARANTEE.

Printed in China

MINUTE SETTING(+30)

HOUR SETTING(+1)

TIMER mode indicator

MINUTE SETTING

HOUR SETTING

SECOND SETTING

ALARM mode indicator

TIME ZONE SETTING

MINUTE SETTING

HOUR SETTING

NREZ009.indd 2 15/05/07 16:29

Lorus Z009 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Lorus Z009

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info