Bedienungsanleitung Lowrance Broadband 4G Radar (Seite 4 von 36) (Englisch)

599437

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Contents | Broadband 3G/4G™ Radar Installation Guide

Compliance

The Broadband 3G™ and 4G™ Radars comply with the following regulations:

• FCC Part 15.

• Industry Canada RSS-Gen.

• CE compliant with R&TTE directive.

For further compliance information please refer to our websites:

http://www.simrad-yachting.com/Products/Marine-Radars

http://www.lowrance.com/Products/Marine

http://www.bandg.com/Products

Industry Canada

IC: 4697A-3G4G

Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired

operation of the device.

FCC Statement

FCC IDENTIFIER: RAY3G4G

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

 Note: This equipment has been tested and complies with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a normal installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. This device must accept

any interference received, including interference that may cause undesired operation.

If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment o and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an output on a circuit di erent from that to which the receiver is

connected.

Consult the dealer or an experienced technician for help.

 Note: A shielded cable must be used when connecting a peripheral to the serial ports.

Changes or modi cations not expressly approved by the manufacturer could void the user’s

authority to operate the equipment.

Radar Transmit Emissions

 Note: Broadband 3G™ and 4G™ Radar are the second generation marine recreational radar

from Navico that has Human Exposure Level RF Radiation of the Radar Transmitter outside

the Radome well below the general public safety emission level of 1 mW/cm

. This means the

radar can be mounted safely in locations impossible with other pulse radars.

 Note: If a pulse radar and Broadband Radar are mounted on the same vessel, do not transmit

simultaneously as excessive interference is possible.

The Broadband Radar will not trigger X Band radar transponders, beacons, and

SARTs due to the low output power and signal properties.

RADAR_3G_4G_IG_988-10113-003_EN_P.indd 2 2/11/2011 6:08:32 p.m.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Lowrance Broadband 4G Radar Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info