23
4. Press
ENTER. Use the arrow keys to input the desired name for the
temp sensor and press
ENTER. Press EXIT repeatedly to return to the
main display.
To reset device name to default setting:
1. Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
BUS SETUP and press ENTER, to open the Bus Configuration
menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
ENTER. The Device
Configuration menu will appear with the Device Name dialog box
highlighted.
4. Press
ENTER. Depress the left arrow key until the device name
disappears. Press
ENTER, then press EXIT to return to the NMEA 2000
menu.
5. Highlight the device and press
ENTER. The Device Configuration
menu will open. The device name will be reset to its default setting.
Press
EXIT repeatedly to return to the main display.
To select Temp Type:
1. Press
MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
BUS SETUP and press ENTER, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the desired temp sensor and press
ENTER. The Device
Configuration menu will appear.
4. Highlight
TEMP TYPE and press ENTER. The following temp options
will appear: Water, Outside, Inside, Engine Room, Cabin, Live Well,
Bait Well, Refrigeration, Heating System and Unknown (default).
5. Highlight the desired Temp Type and press
ENTER. The following
confirmation message will appear: Are you sure you wish to change this
device's configuration?
6. Highlight
YES and press ENTER. Press EXIT repeatedly to return to
the main display.
