199
4. Press ↓ to
FLUID TYPE and press ENT, which will open the Fluid Type
menu with the following options: Fuel, Water, Gray Water, Live Well,
Oil, Black Water and Unknown.
5. Select the desired fluid type and press
ENT. The following message
will appear: Are you sure you wish to change this device's configuration?
6. Highlight
YES and press ENT. Press EXIT repeatedly to get back to the
main display.
To input Tank Size:
1. Press MENU| MENU, use ↑ ↓ to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel
Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
BUS SETUP and press ENT, which will open the Bus Configuration
menu. A list of network devices will be at the top of the page.
3. Select the desired fluid level and press
ENT. The Fluid Level Device
Configuration menu will appear.
4. Highlight
TANK SIZE and press ENT. Use ↑ ↓ ,← → to input the size of
the tank and press Enter. The following message will appear: Are you
sure you wish to change this device's configuration?
5. Select
YES and press ENT. Press EXIT repeatedly to get back to the main display.
Advanced Options menu
The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to
resolve certain electronic probe conflicts. This is most likely to occur if
the network includes LMF-200 or LMF-400 digital gauges, which
support the display of fewer electronic probes than your GPS or
sonar/GPS unit. If you want to use your unit in a network including one
of these digital gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to a
network with similar display units and/or a series of electronic probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-15
Fluid Level Sensor's settings to factory defaults. If, for example, you
execute the Restore Defaults command from your Gray Water Fluid
Level Advanced Options menu, only the settings for the Gray Water
Fluid Level will be reset to factory defaults. Other fluid levels on the
network will not be affected.
