5
Section 2:
Installation & Accessories
Preparations
You can install the sonar system in some other order if you prefer, but
we recommend this installation sequence:
Caution:
You should read over this entire installation section before
drilling any holes in your vessel!
1. Determine the approximate location for the sonar unit, so you can
plan how and where to route the cables for the transducer and power.
This will help you make sure you have enough cable length for the
desired configuration.
2. Determine the approximate location for the transducer and its cable
route.
3. Determine the location of your battery or other power connection,
along with the power cable route.
4. Install the transducer and route the transducer cable to the sonar
unit.
5. Install the power cable and route it to the sonar unit.
6. Mount the sonar unit.
Transducer Installation
These instructions will help you install your Skimmer
transducer on a
transom, on a trolling motor or inside a hull. Please read all
instructions before proceeding with any installation.
Skimmers typically use a one-piece, stainless steel mounting bracket.
The trolling motor mount uses a one-piece plastic bracket with an
adjustable strap.
These are all kick-up mounting brackets. They help prevent damage if
the transducer strikes an object while the boat is moving. If the
transducer does kick-up, the bracket can easily be pushed back into
place without tools.
Read these instructions carefully before attempting installation.
Determine which of the mounting positions is right for your boat.
Use extreme care if mounting the transducer inside the hull, because
once it is epoxied into position, the transducer usually can not be
removed.
