Copyright © 2014 Lumigon A/S - All rights reserved
Copyright © 2014 Lumigon A/S - All rights reserved
30
31
Water and dust resistance (IP rating)
The device has undergone certied tests to measure its
resistance levels to dust and water and complies with the
Ingress Protection (IP) rating IP55. The rst digit in the IP
rating indicates the level of protection against solid objects,
including dust. The second digit indicates the resistance level
to water. The higher the numbers, the higher the respective
protection.
The device’s IP rating IP55 means that the device is dust-
resistant and is protected against low-pressure water jets.
All compatible accessories, including chargers, micros USB
cables, headsets, etc. are NOT waterproof and dust-resistant
on their own.
• DO NOT expose the device to conditions outside
the IP55 classication, including but not limited
to sand/mud, salt water, high-pressure water jets,
liquid chemicals, or environments with excessive
dust, moisture or extremely high or low humidity and
temperatures. Lumigon’s warranty will not cover
damages caused by any such conditions.
• If the device gets wet, DO NOT dry it using an oven or
dryer, as this may damage your device.
• After using the device in water (in accordance with its
IP rating IP55), dry off the areas around the SIM card
tray, micro USB port, the headset jack, speaker and
microphone and let the phone dry at room temperature.
• Always ensure that the USB port and the headset jack
are dry before using them.
NOTE: The waterproof ability of the micro USB port and the
headset jack is not guaranteed in all environments or
conditions. Normal wear and tear along with damage
to your device can reduce its ability to resist dust or
moisture. Your warranty does not cover damage or
defects caused by improper use and by liquid getting
inside the device.
Dramatic changes in temperature or
humidity
When you move your device between environments with very
different temperature and/or humidity ranges, condensation
may build up on or within the device.
• Avoid using the device after a dramatic change in
temperature or humidity.
• Allow the device to acclimatize to the change in
temperature before turning on power and allow
sufcient time for the condensate, if any, to evaporate
before using the device.
Mounting accessories
• DO NOT use the device on an unstable table, cart, stand,
tripod, or bracket, etc.
• Always use mounting accessories recommended by the
manufacturer and follow the manufacturer’s mounting
instructions.
Use the device with approved equipment
• When using the device together with other equipment,
e.g. computers, make sure the equipment is identied
as compatible for use with the device.
• The device should only be connected to other devices
with the USB interface of version 2.0 or higher.
Cleaning
• Before cleaning, unplug the device from the power
outlet.
• DO NOT use liquid cleaners or aerosol cleaners.
