161
VITROCERAMIC COOKING HOB
– See page 148.
Important:
Before any operation of cleaning
and maintenance disconnect the
appliance from the electrical sup-
ply and wait for it to cool down.
Attention
The appliance gets very hot,
mainly around the cooking areas.
It is very important that children
are not left alone in the kitchen
when you are cooking.
Do not use a steam cleaner
because the moisture can get into
the appliance thus make it unsafe.
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a soft cloth.
Acidic substances like lemon juice,
tomato sauce, vinegar etc. can damage
the enamel if left too long.
6 - CLEANING AND MAINTENANCE
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the oven is cool, unscrew and
replace the bulb with another one
resistant to high temperatures (300°C),
voltage 230 V (50 Hz), 15 W, E14.
Note: Oven bulb replacement is not
covered by your guarantee.
STAINLESS STEEL MODELS
STAINLESS STEEL SURFACES
The stainless steel front panels on this
cooker (facia, oven door, bottom panel)
are protected by a finger-print proof lac-
quer.
To avoid damaging this lacquer, do not
clean the stainless steel with abrasive
cleaners or abrasive cloths or scouring
pads.
ONLY SOAP/WARM WATER MUST
BE USED TO CLEAN THE STAINLESS
STEEL SURFACES.
STAINLESS STEEL AND ALUMINIUM
PARTS - PAINTED AND SILK-SCREEN
PRINTED SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratching
and abrasion. You are advised to use a
soft cloth and neutral soap.
CAUTION: Do not use abrasive sub-
stances or non-neutral detergents as
these will irreparably damage the pro-
tective surface.
