Bedienungsanleitung M-System MVD460 (Seite 15 von 27) (Englisch)

680045

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

• They produce good results for certain types of usage only. If you are using this type of

detergents, y

ou need to contact the manufacturers and find out about the suitable

conditions of use.

• When the conditions of use of such products and the machine settings are appropriate,

they ensure savings in salt and/or rinse aid consumption.

• Contact the detergent manufacturers if you are not obtaining good wash results (if your

dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The scope of

warranty for your machine does not cover any complaints caused by the use of these types

of detergents.

Recommended usage: If you want to obtain better results while using combined detergents,

add salt and rinse aid into your machine and adjust the water hardness setting and the rinse aid

setting to the lowest position.

Solubility of the tablet detergents produced by different companies can vary depending

on the temperature and time. Therefore, it is not recommended to use such detergents

in short programs. It is more suitable to use powder detergents in such programs.

Warning: Should any problem, which you have not encountered before, arise with the use of

this type of detergents, contact the detergent manufacturers directly.

When you give up using combined detergents

• Fill the salt and rinse aid compartments.

• Adjust the water hardness setting to the highest position and run an empty-wash.

• Adjust the water hardness level.

• Make the suitable rinse aid setting.

Filling with rinse aid and making the setting.

Rinse aid is used to prevent the stay of white water drops, lime stains, white film strip-

shaped stains that may form on the dishes, as well as to increase

the drying performance. Contrary to the popular beliefs, it is used

not only for obtaining shinier dishes but also for obtaining sufficiently

dried dishes. For this reason, care

should be taken that there is adequate

amount of rinse aid in the rinse aid

compartment and only polishing

material produced for use at

dishwashers should be used.

To put rinse aid, remove the rinse aid

compartment cap by turning it.1 Fill the rins

e aid compartment with

rinse aid until the rinse aid level indicator becomes dark;2 refit the

cap and close it by turning it in a way

that the nails will correspond to one

another. By checking the rinse aid level indicator on the detergent

dispenser, you can understand whether or not your machine

needs rinse aid. A dark indicator b means that there is rinse aid in

the compartment, while a light indicator a shows that yo

u need to

fill the compartment with rinse aid.

The rinse aid level adjuster can be set to a position between 1 and

6. Factory setting for rinse aid is the position 3.

You need to increase the degree of the adjuster if water stains

form on your dishes after a wash, whereas you need to decrease the degree if a blue

stain is left when wiped by hand.3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

M-System MVD460 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von M-System MVD460

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info