Rinse aid
Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by pressing the release button (A).
2. Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position
1 minimum dosage, position 6 maximum dosage).
The dose is factory set in
position 4.
Increase the dose if there are
drops of water or lime spots
on the dishes after washing.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the indicator light on the control
panel illuminates.
● If you are using dishwasher detergent that already contains
rinse aid, the detergent including the rinse aid must be
placed in the detergent compartment.
In this case the rinse aid dispenser must be deactivated, in
order to avoid a double dosage.
Deactivation/activation of the rinse aid
dispenser
(The dishwasher must be switched off)
Factory setting: rinse aid dispenser activated
When the rinse aid dispenser has been deactivated, also
the rinse aid indicator light on the control panel is
automatically deactivated.
1. Press the On/Off button. The indicator lights of the
programme selection buttons will illuminate and in the digital
display are visible 2 horizontal lines (--) (setting mode).
If other button indicator lights are on and in the digital
display is visible the number of a programme (1 - 2 - 3 etc..),
this means that a washing programme has been set.
The programme must be cancelled: press the button
Cancel for about 3 seconds.
The indicator lights of the programme selection buttons will
illuminate and in the digital display will appear 2 horizontal
lines, this means that the set washing programme has
been cancelled and the machine is now in setting mode.
2. Press simultaneously function buttons 2 and 3, the indicator
lights of the function buttons 1, 2 and 3 start flashing.
3. Press the function button 2, the indicator lights of function
buttons 1 and 3 turn off while the indicator light of the button
2 goes on flashing, the digital display indicates the current
setting.
4. To change the setting, press again the function button 2, the
digital display indicates the new setting.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off button or wait about 60 seconds after
which the dishwasher will automatically return to setting
mode.
32
Rinse aid dispenser deactivated
Rinse aid dispenser activated (factory setting)
