Bedienungsanleitung Mac Allister MAC1700RMA (Seite 7 von 9) (Englisch)

782304

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

are properly located, add the replacement blade

(22) and screw in the blade bolt (23), tightening

it with the blade spanner (11).

Return the blade spanner (11) to its storage

position in the cable tidy (10).

Press down on the blade spanner (11) to lock it

in position under the retaining latch.

Return the mower to the upright position and

replace the grass box (19).

Reconnect the power cable to the supply and

run the mower for a few minutes to check that

the blade is properly tted and that there is no

undue noise or vibration.

Use only the blade as recommended by the

manufacturer.

CLEANING THE FILTER

To help maintain good airow within the grass

box and thus ensure optimum lling, regularly

check and, if necessary, clean the lter (27).

Access the lter by using a at blade screwdriver

to prise off the lter cover (26).

Take out the lter, wash it in warm, soapy water,

rinse it and allow it to dry.

Clean out the lter area and replace the lter

and the lter cover (26).

NOTE. This lter is a consumable item and not

a warranty item.

MAINTENANCE

Store the tool, instruction manual and

accessories in a secure, dry place. You will

then always be able to refer to the relevant

information when required.

In order to take up less space when storing the

mower, loosen both wing knobs (9) and fold the

upper handle (1) over the lower handle (17).

When not in use, keep the cord wrapped

around the cable tidy.

Keep the tool’s air vents accessible when the

cover (13) is raised, unclogged and clean at all

times.

Remove dust and dirt regularly.

Clean inside the mower body and under the

deck. Use a brush or damp rag.

At the end of the season, give the mower

an overall cleaning and a thorough check,

including the blade. Have the blade sharpened

or replaced if necessary.

You can clean out the grass box with a hose or

pressure cleaner provided that you rst remove

it from the mower. Replace the grass box when

it is dry.

Do not let water come into contact with the

motor.

Never use chemicals such as petrol or solvents

to clean plastic parts.

Never disassemble the tool or carry out any

repairs.

Always have the mower maintained or repaired

by a competent person at an authorised service

centre.

GENERAL INSPECTION

Regularly check that all xing screws are tight.

They may vibrate loose over time.

PLUG REPLACEMENT

If you need to replace the tted plug then follow

the instructions below.

IMPORTANT. The wires in the mains lead are

coloured in accordance with the following code:

Blue – Neutral Brown – Live

As the colours of the wires in the mains lead

of this appliance may not correspond with the

coloured markings identifying the terminals in

your plug, proceed as follows. The blue wire

must be connected to the terminal which is

marked with N or coloured black. The brown

wire must be connected to the terminal which is

marked with an L or coloured red.

WARNING. Never connect live or neutral wires

to the earth terminal of the plug.

Only t an approved 13 Amp BS1363/A plug

and the correct rated fuse.

NOTE. If a moulded plug is tted and has to

be removed take great care in disposing of the

plug and severed cable, it must be destroyed to

prevent engaging into a socket.

VII - Guarantee

Thank you for investing in MacAllister.

These products have been made to demanding,

high quality standards and are guaranteed for

domestic use against manufacturing faults for a

period of 36 months from the date of purchase.

To take advantage of this free extended

warranty please register on the website. This

guarantee does not affect your statutory rights.

If your product fails due to a defect in material or

workmanship during this period, please return it

to your nearest B&Q store.

Normal wear and tear, including accessory

wear, is not covered under guarantee. The

product is guaranteed for 12 months if used for

normal trade purposes. Any guarantee is invalid

if the product has been overloaded or subject

to neglect, improper use or an attempted

repair other than by an authorised agent.

Heavy duty, daily professional or hire usage

are not guaranteed. Due to continuous product

improvement, we reserve the right to change

the product specication without prior notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mac Allister MAC1700RMA Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info