Bedienungsanleitung Macrom 42 26 (Seite 9 von 37) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

166336

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

MACROM INGLESE 42.15 - 42.17 17 FEBBRAIO 199310

CONNECTIONS

CONNECTIONS ( Fig. 3 Pag. 4 )

1 Positive output terminal for left speaker or positive output terminal if used in MONO

2 Negative output terminal for left speaker

3 Positive output terminal for right speaker

4 Negative output terminal for right speaker or negitive output terminal if used in MONO

5 RCA-type input connector, left channel or mono

6 RCA-type input connector, right channel

7 20/25 Ampere fuse

8 Feed terminal + 12 V to the battery

Connect this terminal directly to a positive (+) terminal of the battery by means of a lead

responding to the amplifiers power requirements.

9 Terminal for the connection of the negative ground lead

10 Terminal for REMOTE switch-on

1. Battery lead . Connect this terminal (+BAT)➇ directly to the battery cable of the car, by using

an adequately sectioned cable (yelow).

Do not connect this lead to circuits existing within the electric system of the car. In order to avoid

damage to the car it is imperative that this lead be fitted with a fuse (not supplied) as near as

possible to the car‘s battery. This connection is to be carried out last.

2. REMOTE switch-on lead (blue). Connect this lead to the remote switch-on lead or connect the

control lead of the power antenna coming from the head unit to the REMOTE terminal ➉.

NOTE: If this lead is not connected, the amplifier will not be switched on when the head unit is

switched on. If your head unit is not fitted with an outlet for a power antenna, a quick-break lever

switch (SPST) should be installed between the power source (+12 V) and the remote switch-

on lead and connected to the REMOTE ➉ terminal so as to allow the manual activation of the

amplifier.

3. Ground lead . Secure the ground lead to a clean spot on the car chassis and to the GND terminal

➈. Make sure that there is electric continuity between this spot and the negative terminal of the

battery. Use the shortest possible ground cable and if more than one amp should be used,

connect the relative ground to one sole point.

4. FUSE. In case of fuse replacement be sure to use fuses of the same amperage.

The use of fuses with the wrong amperage may seriously damage the components of the unit.

5. SPEAKER OUTLET TERMINALS. Be sure to keep the right polarity and phase in connecting

the speakers. This includes the control of the right polarity, positive (+) and negative (-). NOTE:

Avoid any contact between stripped wires and the ground lead.

6. RCA INPUT CONNECTORS. The line output leads of your head unit should be connected to

the RCA input connectors, respectively RCA right ≈ and RCA left ➄ , by means of a RCA

extension cable ( e.g. 90.05-90.10-90.25-90.50 by MACROM). Be sure to respect the right

channel designation: left (white) and right (red).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Macrom 42 26 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info