Bedienungsanleitung Macrom 44.05 (Seite 8 von 44) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

494089

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

MACROM INGLESE 44.05/07 14 OTTOBRE 1992 10

CONNECTIONS

CONNECTIONS (Fig. 2, page 3)

13 Positive output terminal, speaker A, or positive output speaker E

14 Negative output terminal, speaker A

15 Positive output terminal, speaker B

16 Negative output terminal, speaker B, or negative output speaker E

17 Positive output terminal, speaker C, or positive output speaker F

18 Negative output terminal, speaker C

19 Positive output terminal, speaker D

20 Negative output terminal, speaker D, or negative output speaker F

21 2x20/2x25 A fuses

22 Power supply terminal +12 V to the battery (BATT)

23 Terminal for connection of the negative ground lead (GND)

24 Terminal for remote switch-on (REMOTE)

25 Check control status indicator

CONNECTIONS:

Battery lead: Connect the terminal BATT 22 to the battery cable of the car by means of a

(yellow) cable of adequate section.

Do not connect this lead to circuits existing within the electric system of the car. In order to avoid

damage to the car it is imperative that this lead be fitted with a fuse (not provided) as near as

possible to the battery. This connection is the to be carried out last.

Remote switch-on lead: Connect the remote switch-on lead (REMOTE) or the control lead of

the power antenna coming from the head unit (blue) to the REMOTE 24 terminal of the amplifier.

NOTE: In case this lead is not connected, the amplifier will not be switched on when the head

unit is switched on. If your head unit is not fitted with an outlet for a power antenna, a quick-break

lever switch (SPST) shall be installed between the power source (+12 V) and the remote switch-

on lead and connected to the REMOTE 24 terminal so as to provide for manual switch-on of

the amplifier.

Ground lead: Secure the ground lead (black) to a clean spot on the car chassis and to the GND

terminal 23 . Make sure that there is electric continuity between this spot and the negative

terminal of the battery. The ground cable should be as short as possible; in case more than one

amps are used, connect all the ground connectors to one spot.

Fuse: In case of fuse replacement make sure to replace it with a fuse of the same amperage.

The use of fuses with the wrong amperage may seriously damage the components of the unit.

Speaker outlet terminals: Make sure to keep the right polarity and phase on connecting the

speakers. This includes the control of the right polarity, positive (+) and negative (-).

NOTE: The negatives of the speakers should NEVER be connected witch each other and no

common ground lead must be used.Non adequately isolated wires should never come into

contact with each other, with metallic parts of the car or with the ground lead.

RCA input connectors: Connect the Pre output leads of your head unit to the RCA input

connectors by means of RCA extension cables (90.05-90.10-90.25-90.50 by MACROM).

Make sure to observe the right channel designation: left L (white) and right R (red).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Macrom 44.05 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info