en 5
Installing Your iPhone or iPod touch
Caution: Avoid touching the o-ring that is
installed in the lid of the ToughCase GPS
receiver. Tampering can shorten the life of
the o-ring which will impact the water tight
seal.
Lift the locking flaps on both sides of the
ToughCase GPS receiver and pivot the lid
upwards. The Master Power switch (upper left
side) is accessible when the lid is open. Switch
it to ON.
Connect your iPhone to the dock connector.
If using an iPod touch, you need to place your
iPod touch into the Sleeve (supplied) and
then connect the assembly to the dock
connector.
Close the lid and hold the lid shut while
snapping the locking flaps until you hear a
‘click.’
Note for iPod touch Users: Before using your
iPod touch in the ToughCase GPS receiver
you should turn off Auto-Brightness. On your
iPod touch select Settings > Brightness and
turn off the Auto-Brightness feature.
Turning the ToughCase GPS Receiver
Off
The ToughCase GPS receiver can be turned
off to prevent unnecessary battery drain
while being stored or during travel.
Release the Locking Flaps and open the
ToughCase GPS receiver. Remove your
iPhone or iPod touch from the ToughCase
GPS receiver. This reveals the Master Power
switch. Slide it to OFF to keep battery charge.
