Bedienungsanleitung Magic MGC HC 2 R (Seite 12 von 48) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

487451

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity.

12 MGC HC 2 R - 080609

Assembly page 12/48

Fax +32 2 359 95 50

Short cuts

Always cut from the back of the neck to the crown, with the 6 mm comb attachment. Holding

it flat against the head, slowly move the clipper up through the hair. Use the same technique

for the sides, cutting from the bottom to the upper side of the head (14).

For the front of the crown, cut the hair against the direction in which it grows. Then even it up

with the sides (15).

To taper hair down to the neckline, use the 4 mm attachment comb. Comb hair, check for

uneven spots and outline sideburns and neckline. (16)

CUTTING WITHOUT THE COMB ATTACHMENT

To cut the hair with the help of a comb or your fingers as well as to cut the outlines, you do not

need the comb attachment.

Take off the comb attachment by pulling it holding it by the sides.

Cutting hair with the help of a comb or your fingers

Remove the comb attachment carefully, as explained in the previous paragraph.

Raise a wisp of hair with the help of the comb (17), or take the wisp between your fingers (18).

Take the wisp through the comb or fingers until only the desired hair length remains under the

comb/fingers. Cut the hair that is above the comb or fingers with the hair clipper (19 and 20).

Outlining

 Outlining requires no attachments, apply directly the blades on the hair.

 Comb hair into the required style. Position clipper between the sideburns and the ear. Make

sure the outer edge of the blade is against the hairline. With the outline of the hair as your

guide, slowly move the clipper around the ears (11). For the back of the neck and the

sideburns, hold the clipper upside down (13), and move downwards holding it against the

skin at the length desired. If necessary, insist on thicker hair.

 After you acquired a certain experience, you’ll be able to do layered cuts simply by

changing the haircut height according to the part of the head but this manipulation

requires a certain skill to obtain a good result.

MAINTENANCE

 Your clipper was carefully examined before leaving our factory to ensure that the blades

were oiled and aligned. To maintain your clipper in peak condition, the blades should be

oiled every few haircuts.

 Remove the blades as indicated on page 2 “A1”.

 Use the small brush to remove remaining hair.

 Lubricate the blades as indicated on page 2 “A2”.

 Put the blades back in place as indicated on page 2 “A3”.

 Change the blades as soon as they become blunt.

DISPOSAL OF BATTERY

When you decide to throw out your appliance, first remove the battery in order to protect the

environment.

 The appliance has to be disconnected from the power supply when you remove the

battery.

 Remove the blades as indicated on page 2 “A1”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Magic MGC HC 2 R Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info