Bedienungsanleitung Magnat Black Core One (Seite 8 von 44) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch)

581726

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

The +12 Vamplifierconnection must then be connected withapower cable possessing an integratedfusetothe battery’s pluspole.The

fuse must belocatedclose to the battery, the lengthofcable from the battery’s positive poletothe fuse must belessthan 60 centimetres

for safety reasons.Onlyinsert the fuse whenallinstallationwork,including the connection oftheloudspeakers,has been completed.

Nowconnectthecarhi-fireceiver’sremotecontrolconnectiontotheamplifier’sREMcontroljack.Acablewithacross-sectionof0.75mm²

is sufficient for connectingtheamplifier’s REMOTE connectionandthe control device.

4.2 AUDIOCABLES

Wheninstallingthe audiocable betweenthecinchoutputofyourcarreceiver andthe cinchinput ofthe amplifierinside yourcar,the audio

and power supply cables should, wherever possible, not be routed along the same side of the vehicle. We recommend an isolated

installation, e.g. routing the power cable through the cable duct on the left-hand side and the audio cable through the cable duct on the

right-hand side orviceversa. This reducesinterferencedue to crosstalk intotheaudio cables.

This also applies totheconnecting cable for the remote controlforregulatingthe volume. This cableshouldnotbe laid on the side ofthe

power supply leadsbuttogether with the audio cable.

4.3 LOUDSPEAKERCONNECTIONS

· The lowest terminalresistanceis1 ohm

· Never connect theloudspeakers’minus terminals to thevehiclechassis.

· Never connect the+12V supply voltagetoaloudspeaker output as thiswoulddestroy the amplifier final stage.

If the amplifier is operated with lower terminal resistances or incorrectly used as described above, both the amplifier and the

loudspeakers may bedamaged.The warranty becomesvoidin such cases.

5. OPERATINGELEMENTSANDIN/OUTPUTS

5.1 SETTINGTHEINPUTSENSITIVITY

The input sensitivitymay be adapted to anycar radio or tape deck. Turn the volume control of your radio to its central position and then

adjusttheinput-levelcontrol(2)toproduceanaveragemediumvolume.Thissettingusuallyprovidessufficientpowerreservesatoptimum

weighted noise voltage.

ATTENTION:only reproduce loudtestnoises briefly to prevent damagingtheloudspeakers.

5.2 LOW-PASSFILTERWITHADJUSTABLECROSS-OVERFREQUENCY

Setthedesiredcross-over frequencywith thecontrol (4).Thismakesthefilteradaptabletotheinstalledwoofer’ssoundrequirements.The

filter’shighedgesteepness is responsible fortheprecision reduction of medium andhighfrequency ranges.

5.3 SUBSONICFILTER

Thesubsonicfunctionreducesthelowestbassfrequencies.Thereductionratemaybeinfinitelyadjustedwiththeregulator(5).Thisallows

distortions produced by excessive loudspeaker membrane movements to be effectively minimized without reducing the utilizable bass

levels.

5.4 BASS-BOOST

The bass-boost function(3)is used to increaseorequalizethe lower bass frequencies.

5.5 VOLUMEREMOTECONTROL

Thevolume maybe adjustedby usingthe suppliedremote control.Pleaseobserve duringinstallationthattheremotecontrollineshouldn’t

beroutedalong thesame sideofthe vehicleasthe powersupply cables.The remotecontrol unitshouldbemountedon thedashboard or

at any othereasilyaccessible position. Now,thesubwoofer volume may beadjustedindependentlyfrom the settings attheradio.

5.6 OUTPUTSFORCONNECTINGADDITIONALAMPLIFIERS

The input signal of the INPUT connections INPUT L and R (1) is forwarded directly to the OUTPUT (6) L and R jacks. The OUTPUT

connections allow theuseof additional amplifiers without requiringadditionalT-plugsandcables.

FIG.1 POWERSUPPLY/REMOTESWITCH-ONCONNECTION

(1) GND terminal fortheground, to the battery’s minuspole

(2) REM terminal forremoteswitch-on

(3) Terminal for +12 Vbatteryvoltage

(4) Battery

(5) Cable fuse

(6) To your car radio’s automaticaerialconnection

Ifyourcar isnot equippedwith anautomaticaerialconnection,connectthis cable’spluspole (+)to theignition lock.Anon/offswitch

should be insertedinthis case. Make surethatthisswitch is switched off iftheamplifier is not used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Magnat Black Core One Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info