Bedienungsanleitung Magnat QUANTUM CENTER 73 (Seite 8 von 44) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch)

581686

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

BI-WIRING AND BI-AMPING

Bi-wiring means using separate cables to carry the high and low audio frequencies. Bi-amping takes this

idea one step further and uses separate power ampliers as well as separate cables for high and low

frequencies. Bi-amping in particular produces an additional improvement in sound reproduction quality.

The special connection terminals of the QUANTUM loudspeakers support both conventional connection

and operation in bi-wiring and bi-amping modes. There are four screw terminals on each speaker. The

top pair are for the tweeter (high frequencies), the lower pair for the woofer (low frequencies). The

factory-installed metal strips connecting the positive and negative terminals are for conventional 2-wire

connection and must be removed for bi-wiring and bi-amping operation. The pictures below show the

correct set-up for conventional operation (Fig. 4a), bi-wiring (Fig. 4b) and bi-amping (Fig. 4c).

MAGNAT QUANTUM CENTER 73

The QUANTUM CENTER 73 loudspeaker visually and acoustically ideally matches the other QUANTUM

models. The loudspeaker is placed immediately on or under the television set. Otherwise please adhere

to the general recommendations outlined in the previous chapters.

MAGNAT QUANTUM 731A

The QUANTUM 731A active subwoofer visually and acoustically ideally matches the other loudspeakers

in the Vica series. Please refer to the separate operating instructions supplied with this product.

CONNECTING TO AN AV RECEIVER

Figs. 5 and 6 show two different methods of connecting to AV receivers.

Fig. 5: AV receiver without subwoofer output.

Fig. 6: AV receiver with subwoofer output.

HOW TO AVOID DAMAGE TO YOUR VALUABLE SPEAKERS

All MAGNAT loudspeakers are designed and built for optimum sound reproduction with the tone controls

in the central position – i.e. with “linear” amplier output. Turning up the bass and treble controls too far

delivers more power to the woofers and/or tweeters, and at high volumes this can actually destroy the

speaker units!

If the output of your amplier is signicantly higher than the rated power handling capacity of your

speakers extremely high volumes can physically destroy your speakers. This doesn’t actually happen

often but you should be aware that it is possible.

Weak ampliers with low output ratings can actually be more dangerous for your speakers at medium

volumes because weak ampliers may overload much faster than powerful ones and this causes

measurable and audible distortion, which is extremely dangerous to your loudspeakers.

Always turn the volume down immediately as soon as you hear distortion! If you like listening to loud music

make sure that your amplier can deliver at least as much power as the speakers’ power-handling rating.

THE SOUND YOU CAN’T HEAR...

Ampliers, tuners and CD players can all produce inaudible high-frequency signals – and this doesn’t

only apply to cheap products. If your tweeters fail at low or medium volumes you should have a qualied

technician check your system components for dangerous inaudible signals.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Magnat QUANTUM CENTER 73 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info