534675
23
Zoom out
Zoom in
Vorherige Seite
1/116
Nächste Seite
23STARTUP
LEVELING THE BUILD PLATE CONTINUED
2
Adjust Each Knob Again
The script will prompt you to adjust each
knob again. This allows for fine tuning. This
time, the Support card should slide between
the build plate and nozzles with more friction.
3
Confirm your Adjustment
Aer the second set of adjustments, the
nozzles will move to the center of the build
plate. Confirm that the MakerBot Support
card slides between the nozzles and plate
with a moderate amount of friction.
NOTE: During leveling, it is okay for the nozzle to
be very slightly closer to the center of the build
plate than to the rest of the plate.
4
Finish Leveling
When you have completed the initial
leveling tasks, the LCD menu will display
the following text: “Aaah, that feels much
better. Let’s go on and load some plastic!”
Before you can print, you must load the
MakerBot ABS Filament into the extruder.
The extruder will heat the filament and use
the melted material to build things.
NOTE: If you have problems with this process or
if you need to level your build plate again, you can
use the up and down arrows to scroll through the
top-level menu on the LCD panel and use the M
button to select Utilities. Scroll to Level Build Plate
and select it. You can use these menus to return to
the leveling script at any time.
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MakerBot Replicator 2X wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info