534675
78
Zoom out
Zoom in
Vorherige Seite
1/116
Nächste Seite
Infill. Everything that is neither shells, nor
floor, nor roof is filled with an internal lattice
called infill. [Fig. 11.2] Infill provides your
object with an internal support structure.
The number that you enter in this field
defines the solidity of the printed object’s
infill. Higher infill percentages will result
in more threads of infill extrusion that are
closer together. Lower infill percentages will
result in fewer threads of infill extrusion that
are more widely spaced. For a hollow object
with no internal support structure, enter an
infill of 0%. For a completely solid object,
enter 100%.
For decorative objects, you might want to
set a low infill percentage--maybe 5 or 10%.
If you are having trouble with the upper
surfaces of your object, you might want
to raise that number. Flat roofs must have
some structure underneath them so that
they do not sag. Rounded objects might
show gaps if there is not enough infill for the
shells of new layers to adhere to.
More infill will increase the strength and
weight of your object. It will also increase the
printing time for the object. For objects with
a practical purpose, you should use more
infill. An infill of 40 or 50% usually results in
a robust object, but if you are able to crush or
break your object, try raising the amount of
infill by 10%.
PRINT QUALITY CONTINUED
78
File Name: 20mm calibration box Fig. 11. 2
Design by: Spacexula
Thingiverse: 2064
78

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MakerBot Replicator 2X wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info