Bedienungsanleitung Makita da 302dwb (Seite 5 von 76) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

386318

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

CAUTION:

• The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufac-

turer’s batteries.

• When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it

may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the bat-

tery cartridge fully after discharging it completely and recharging a couple of times.

• When you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location

exposed to direct sunlight or heat for a long time, let it cool off. Then re-insert it and try to charge it once more.

• When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, some-

times the charging light will go out soon. If this occurs, remove the battery cartridge and re-insert it. If the charging

light goes out within one minute even after repeating this procedure a couple of times, the battery cartridge is dead.

Replace it with a new one.

For DC9711

Plug the battery charger into your power source. Insert the battery cartridge so that the plus and minus terminals on

the battery cartridge are on the same sides as their respective markings on the battery charger. Insert the cartridge

fully into the port so that it rests on the charger port floor.

When the battery cartridge is inserted, the charging light will come on and charging will begin. The charging light will

keep lighting up steadily during charging. When charging is completed, the charging light goes out. If you leave the

battery cartridge in the charger after the charging cycle is complete, the charger will switch into its “trickle charge

(maintenance charge)” mode which will last approximately 24 hours. After charging, unplug the charger from the

power source. Refer to the table below for the charging time.

CAUTION:

• The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufac-

turer’s batteries.

• If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location

exposed to direct sunlight for a long time, the charging light may flash in red color. If this occurs, wait for a while.

Charging will begin after the battery cartridge cools.

• Any of the following conditions indicates damage to the charger and/or battery cartridge. Ask your Makita Authorized

or Factory Service Center to check them.

1)The charging light does not light up when the battery is inserted in the charger port.

2) Charging is not completed at even more than three hours after red light comes ON at start of charging.

For DC1413

Plug the battery charger into the proper A/C voltage source. The charging light will flash in green color. Insert the bat-

tery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective

markings on the battery charger. Insert the cartridge fully into the port so that it rests on the charger port floor. When

the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The

charging light will remain lit steadily during charging. When the charging light color changes from red to green, the

charging cycle is complete. If you leave the battery cartridge in the charger after the charging cycle is complete, the

charger will switch into its “trickle charge (maintenance charge)” mode which will last approximately 24 hours. After

charging, unplug the charger from the power source. Refer to the table below for the charging time.

Battery type Capacity (mAh) Number of cells Charging time

7033 2,200 6 Approx. 100 min.

9122 2,000 8 Approx. 90 min.

9134 2,600 8 Approx. 115 min.

9135 3,000 8 Approx. 130 min.

Battery type Capacity (mAh) Number of cells Charging time

1202, 1202A, 1222 2,000 10 Approx. 60 min.

1200, 1220 1,300 10 Approx. 40 min.

1233 2,200 10 Approx. 65 min.

1234 2,600 10 Approx. 75 min.

1235 3,000 10 Approx. 90 min.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita da 302dwb Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Makita da 302dwb

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info