Bedienungsanleitung Makita DC18SD (Seite 6 von 40) (Alle Sprachen)

657225

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

ENGLISH

WARNING: This appliance can be used by children aged from 8

years and above and persons with reduced physical, sensory or

mental capabilities or lack of experience and knowledge if they have

been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance. Cleaning and user

maintenance shall not be made by children without supervision.

CAUTION:

1. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery charger.

2. Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using

battery.

3. CAUTION – To reduce risk of injury, charge only Makita type rechargeable batteries. Other types of batteries may burst causing

personal injury and damage.

4. Non-rechargeable batteries cannot be charged with this battery charger.

5. Use a power source with the voltage specified on the nameplate of the charger.

6. Do not charge the battery cartridge in presence of flammable liquids or gases.

7. Do not expose charger to rain or snow.

8. Never carry charger by cord or yank it to disconnect from receptacle.

9. After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull by plug rather than

cord whenever disconnecting charger.

10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

11. Do not operate charger with damaged cord or plug. If the cord or plug is damaged, ask Makita authorized service center to replace it

in order to avoid a hazard.

12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a

qualified serviceman. Incorrect use or reassembly may result in a risk of electric shock or fire.

13. Do not charge battery cartridge when room temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F). When the battery

temperature is under 0°C (32°F), charging may not start.

14. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.

15. Do not allow anything to cover or clog the charger vents.

Charging

1. Plug the battery charger into the proper AC voltage source. Charging light will flash in green color repeatedly.

2. Insert the battery cartridge into charger until it stops adjusting to the guide of charger. Terminal cover of charger can be opened with

inserting and closed with pulling out the battery cartridge.

3. When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging

light will keep lighting up lit steadily during charging. One red charging light indicates charged condition in 0 – 80% and red and green

ones indicate 80 – 100%.

4. With finish of charge, the charging lights will change from red and green ones to green one.

5. Charging time varies by temperature (10°C (50°F) – 40°C (104°F)) that battery cartridge is charged at and conditions of the battery

cartridge, such as a battery cartridge which is new or has not been used for a long period of time.

6. After charging, remove the battery cartridge from charger and unplug the charger.

NOTE:

• The battery charger is for charging Makita-battery cartridge. Never use it for other purposes or for other manufacturer’s batteries.

• When you charge a battery cartridge which is new or has not been used for a long period of time, it may not accept a full charge until

after discharging it completely and recharging a couple of times. (Ni-MH battery only)

• If charging light may flash in red color, battery condition is as below and charging may not start.

– Battery cartridge from just-operated tool or battery cartridge that has been left in a location exposed to direct sunlight for a long time.

– Battery cartridge that has been left for a long time in a location exposed to cold air.

Charging will begin after the battery cartridge temperature reaches the degree at which charging is possible.

• If the charging light flashes alternately in green and red color, charging is not possible. The terminals on the charger or battery cartridge

are clogged with dust or the battery cartridge is worn out or damaged.

• DC18SD battery charger cannot use with INTERCHANGEABLE ADAPTER (ADP01, 04) and REFRESHING ADAPTER (ADP02, 03).

Voltage 9.6 V 12 V 14.4 V Capacity (Ah)

according to

IEC61951-2

Charging time (Minutes)

Number of cells 8 10 12

Ni-MH Battery cartridge

B9017A — — 1.7 40

BH9020/A — — 1.8 40

— BH1220/C BH1420 1.8 40

— — BH1427 2.5 55

BH9033/A — — 3.1 70

— BH1233/C BH1433 3.1 70

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita DC18SD Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info