Bedienungsanleitung Makita DCL500 (Seite 9 von 116) (Alle Sprachen)

600559

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

OPERATION

Switch action (Fig. 14)

To start the cleaner, simply press the ON (2/1) button.

To switch off, press the OFF (0) button. To change the

cleaner speed, press the ON (2/1) button. The first press

on this button is for high speed and the second press for

low speed. Each press on this button repeats the speed

change alternatively.

Indicator lamps (Fig. 15)

The indicator lamps light up or flash to indicate the status

of the appliance.

NOTE:

• Always remove dust frequently. Suction power will be

reduced if there is too much dust in cleaner.

MAINTENANCE

CAUTION:

• Always be sure that the appliance is switched off

before attempting to perform inspection or

maintenance.

• Place newspapers or a garbage can underneath to

work over. The newspapers or garbage can will catch

any falling dust from the appliance.

Cleaning the filter (after work) (Fig. 16)

After use, move the filter cleaning lever back and forth

around ten times to loosen dust from the filter.

Disposing of dust

Dispose of dust before the level exceeds the Dust Full

line. The suction power may drop if the level exceeds this

line. Dispose of dust before it reaches the line, including it

accumulates at one side only. (Fig. 17)

To dispose of dust, follow the procedure below.

1. Raise the Cup Release lever to eject the dust cup

assembly. (Fig. 18)

2. Press the button to remove the cover. Dispose of

the dust in the dust cup. (Fig. 19)

3. Use the cleaning brush attached to the dust cup to

brush away dust inside the cup. (Fig. 20)

4. Move the red lever on the filter cover in the direction of

the arrow to flip the filter cover open. (Fig. 21)

5. Grasp the knob and spin it around ten times. (Fig. 22)

6. Close the filter cover. (Fig. 23)

7. Attach the dust cup to the cover. (Fig. 24)

8. Attach the dust cup assembly to the appliance body.

(Fig. 25)

Cleaning the filter (thoroughly cleaning )

(Fig. 26 & Fig. 27)

Wash out the filter if it gets too dirty, when suction power

drops or the orange lamp starts flashing.

Remove the dust cup, filter cover, filter, and cylindrical

filter apart and wash each separately to clean them. Use

plain water or a neutral detergent solution to wash each

part.

After washing the parts, leave them out to fully dry and

then put them back together.

Cleaning the cleaner body

From time to time wipe off the outside (cleaner body) of

the cleaner using a cloth dampened in soapy water.

CAUTION:

• Never use gasoline, benzine, thinner, alcohol or the

like. Discoloration, deformation or cracks may result.

Dry it out thoroughly before use. An insufficiently dried

filter may cause poor suction and shorten the service life

of the motor.

Do not blow dust sticking on the cleaner by air duster. It

brings dust into the housing and causes failure.

STORAGE

Shorten the zoom pipe and insert the hook into the holder

securely. (Fig. 28)

TROUBLE SHOOTING

Before asking for repairs, check the following points.

010051

Filter

indicator

(orange

lamp)

Lighting on The filter is dirty. Clean the

filter. Refer to Section

“Cleaning the filter (after

work)”.

Blinking

rapidly

The filter is clogged with dust.

Wash the filter. Refer to

Section “Cleaning the filter

(thoroughly cleaning)”.

Battery

indicator

(red lamp)

Blinking The battery power is getting

low.

Lighting on The battery is very low and the

appliance will stop. Charge the

battery.

Symptom Area to be investigated Fixing method

Weak suction power

• Is dust cup full of dust?

• Is filter clogged?

• Is battery exhausted?

• Empty dust from dust cup.

• Dust down or wash filter.

• Recharge battery.

Not working • Is battery exhausted? • Recharge battery.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita DCL500 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info