Bedienungsanleitung Makita DST112 (Seite 8 von 68) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

657991

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

8 ENGLISH

Loading staples

WARNING: When loading staples, always

make sure that the battery cartridge is removed

from the stapler.Unintentionalringmaycause

personalinjuriesandpropertydamage.

CAUTION: After loading staples, make sure

that the sub magazine is surely closed. Falling

staplesoutofthemagazinemaycauseaninjuryto

the operator or bystander, especially when working in

high locations.

1. Remove the battery cartridge.

2. Pressthelockingleverandslidethesubmaga-

zine backward.

►Fig.7: 1. Locking lever 2. Sub magazine

3. Load staples into the main magazine with their

feetfacingup.

►Fig.8: 1. Staples 2. Main magazine

4. Afterloadingstaples,pushbackthesub-maga-

zine in place until it clicks.

Toremovestaples,followtheinstallationproceduresin

reverse.

Hook

CAUTION: Do not hang the hook from the

waist belt. Dropping the stapler, which is caused by

thehookaccidentallycomingoutofplace,maycause

unintentionalringandresultinpersonalinjuries.

►Fig.9

Thehookisconvenientfortemporarilyhangingthetool.

Thiscanbeinstalledoneithersideofthetool.

Toinstallthehook,insertitintoagrooveinthetool

housing on either side and then secure it with a screw.

Toremove,loosenthescrewandthentakeitout.

►Fig.10: 1. Groove 2. Hook 3. Screw

OPERATION

Testing the safety system

WARNING: Make sure all safety systems are

in working order before operation. Failure to do

so may cause personal injuries.

►Fig.11: 1.Trigger-lockbutton2. Switch trigger

3. Contact element 4. Sub magazine

Testsafetysystemsforpossiblefaultbeforeoperation

asfollowing.

1. Unload the tool with staples and keep the sub

magazine opened.

2. Install the battery cartridge.

3. Only pull the switch trigger without touching the

contact element against the material.

4. Only touch the contact element against the mate-

rial without pulling the switch trigger.

Ifthetooloperatesinthecaseof3and4above,the

safetysystemsarefaulty.Stopusingthetoolimmedi-

ately and ask your local service center.

Driving staples

WARNING: Until driving staples completely,

always make sure that the contact element placed

rmly on the material.Unintentionalringmay

causepersonalinjuries.

►Fig.12: 1. Switch trigger 2. Contact element 3. Front

part 4. Rear part

Youcanoperatethetoolineitherwayof“single

sequentialactuation”or“contactactuation”.

Single sequential actuation:

Inthismode,youcandriveonestaplebyonesequen-

tial operation.

1. Placeatthecontactelementonthematerial.

2. Holdbothofthefrontpartandtherearpartofthe

toolrmlyagainstthematerial.

3. Pulltheswitchtriggerfullytodrivethestaples.

4. Releaseyourngerfromtheswitchtriggerbefore

movethecontactelementfromthematerial.

Contact actuation:

In this mode, you can drive staples repetitively.

1. Pulltheswitchtrigger.

2. Withtheswitchtriggerpulled,placeatthecon-

tact element on the material to drive the staples.

3. Movethetooltothenextareaandplaceatthe

contact element on the material again.

NOTE:Thegrooveindicatesthepointthatstapleis

driven.

►Fig.13: 1. Groove

Whentheheadofdrivenstapleremainsabovethe

workpiecesurface,drivethestaplewhileholdingthe

staplerheadrmly.

►Fig.14

Thematerialmaybeunsuitable,iftheheadofdriven

stapleremainsabovetheworkpiecesurfacealthough

thestaplerheadisheldrmly.

NOTE: Using the stapler continuously with the head

ofdrivenstaplesremainingabovethesurfaceof

materialmaycausedamagetothedriverofthesta-

plerandstaplerjammingetc.

Anti dry re mechanism

WARNING: When loading staples, always

make sure that the battery cartridge is removed

from the stapler.Unintentionalringmaycause

personalinjuriesandpropertydamage.

Thistoolisequippedwithanantidryremechanism.

Whenthenumberofremainingstaplesinthemagazine

becomes 5 - 8 pcs., the switch trigger can no longer be

pulled.Atthistime,insertanewstripofstaplesinthe

magazine.Theswitchtriggercanbepulledagain.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita DST112 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info