Bedienungsanleitung Makita EG321AE (Seite 15 von 49) (Englisch, Holländisch)

448386

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

OPERATING PROCEDURES

(See Fig. 󱌲)

1. STARTING THE GENERATOR

CAUTION

Check the oil level before each operations as

outlined by the article “CHECK ENGINE OIL”

(a) Turn the Engine switch to the position “ ¦ ” (ON).

(See Fig.󱌲-①)

❶ “ ¦ ” (ON)

❷ “ 〇 ” (OFF)

(b) Open the fuel valve. (See Fig.󱌲-②)

❶ OPEN

❷ CLOSE

(See Fig.󱌲-③)

❶ CHOKE LEVER

❷ CLOSE

❸ OPEN

WARNING

Death, personal injury and/or property damage may

occur unless instructions are followed carefully.

■

Use battery of recommended capacity.

■

Turn the starter switch to the “ 〇 ” (STOP)

position when mounting or dismounting

battery. When mounting battery, connect the

positive (+) cable ﬁ rst and then the negative

(-) cable to the battery. Be careful not to

short battery cables. When dismounting

battery, disconnect negative (-) cable ﬁ rst.

RED CABLE : To positive (+) terminal

BLACK CABLE : To negative (-) terminal

■

Should the connection be made in incorrect

manner, the generator will be broken.

■

Tighten bolts and nuts on terminals securely

so they will not be loosened by vibration.

■

Disconnect battery cables when charging

battery.

(d) [Recoil starter model]

Pull the starter handle slowly until passing the

compression point (resistance will be felt), then

return the handle to its original position

and pull briskly. (See Fig.󱌲-④)

❶ PULL BRISKLY

■

If the engine fails to start after several attempts,

repeat above procedures with choke lever returned

to “OPEN” position.

■

Do not fully pull out the rope.

■

After starting, allow the starter handle to return to

its original position while still holding the handle.

(e) [Electric starter model]

Insert the key into the key switch and turn it

clockwise to the “ ¦ ” (RUN) position to start the

engine.

Then turn the key further to the “

” (START)

position.

The engine will be started by starting motor.

(See Fig.󱌲-⑤)

❶ “ 〇 ” (STOP)

❷ “ ¦ ” (RUN)

❸ “

” (START)

CAUTION

■

Do not run the starting motor over 5 seconds

continuously.

If the engine fails to start, return the key to

the “ ¦ ” (RUN) position and wait about 10

seconds then start again.

■

Do not turn the key switch to “

” (START)

position when the engine is running to

prevent damage of starting motor.

■

When starting the engine by recoil starter,

set the key switch at the “ ¦ ” (RUN) position

and pull the starter handle.

(f) After the engine started, return the choke lever

gradually to “OPEN” position.

(See Fig.󱌲-⑥)

❶ CHOKE LEVER

❷ CLOSE

❸ OPEN

(g) Warm up the engine without a load for a few

minutes.

EG671A_en_GU7107.indd 7EG671A_en_GU7107.indd 7 2010/09/09 13:41:572010/09/09 13:41:57

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita EG321AE Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Makita EG321AE

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info