Bedienungsanleitung Makita EN4951SH (Seite 5 von 50) (Deutsch, Englisch)

599897

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

Refuelling

- Before refuelling, stop the engine.

- 

- Do not smoke when refuelling.

- 

- Take care not to let your skin come into contact with petroleum products. Do not

inhale gasoline fumes and always wear protective gloves when refuelling.

Change and clean protective wear at regular intervals.

- Take extra care to avoid spilling gasoline and oil in order to avoid contamination

of the ground (environmental protection). If gasoline or oil has been spilled onto

the pole hedge trimmer, immediately wipe the surface of the pole hedge trimmer

with a rag.



discarding them into an appropriate, covered container.

- Make sure that no fuel comes in contact with your clothing. Change fuel-



- Close the fuel tank and tighten the fuel tank cap securely. To restart the engine,

transfer the pole hedge trimmer to a location at least 3 meters away from the

place of refuelling.

- Check the fuel tank cap at regular intervals to make sure that the cap is securely

fastened.

- Never refuel the machine in an enclosed room. Fuel vapors accumulate at ground

level (risk of explosion).

- Store fuel in appropriate containers only, and make sure that stored fuel is out of

the reach of children.

Operation

- In the event of an emergency, turn off the engine immediately.

- If you feel any unusual condition (e.g. noise, vibration) during operation, switch off

the engine. Do not use the pole hedge trimmer until the cause is recognized and

solved.

- The blades continue to move for a short period after releasing the throttle trigger

or switch off the engine. Don’t rush to contact the blades.

- Never attempt to operate the equipment with one hand. Loss of control may result

in serious or fatal injury. To reduce the risk of cut injuries, keep your hands and

feet away from the blades.

- Keep your right hand under the shoulder height during operation. Otherwise you

may lose control and result in injury.

- During operation, never hit the blades against hard obstacles such stones and

metals. Take particular care when cutting hedges next to or against wire fences.

When working close to the ground, make sure that no sand, grit or stones get

between the blades.

- If the blades come into contact with stones or other solid objects, stop the engine

immediately and check the blades for damage after removing the spark plug cap.

Replace the blades if damaged.

- Never touch or approach the blades while they are moving. Blades can cut your



remove the spark plug cap.

- If thick branches get jammed in the blades, immediately stop the engine, put the

pole hedge trimmer down and then remove the obstruction after removing the

spark plug cap. Check the blades for damage before using the equipment again.

- Accelerating the engine with the blades blocked increases the load and may

damage the engine and/or clutch.

- Check the cutting blades frequently during operation for cracks or blunt edges.

Before the inspection, switch off the engine and wait until the blades stop

completely. Replace damaged or dull blades immediately, even if they have only



- Do not touch the gear case. The gear case becomes hot during operation.

- Take a rest to prevent loss of control caused by fatigue. We recommend to take a

10 to 20-minute rest every hour.

- Before cutting, pull the throttle lever fully to achieve the maximum speed.

- During operation, hold the pole hedge trimmer with both hands at all times.

- Only use the pole hedge trimmer in good light and visibility conditions. Beware

of slippery and wet areas (ice and snow) during the cold season (danger of

slipping), and always ensure secure footing.

- Never use the pole hedge trimmer while standing on an unstable surface or a

steep slope.

- Never use the pole hedge trimmer while standing on a ladder.

- Never climb a tree to use the pole hedge trimmer from the tree.

- To avoid stumbling or falling over objects, never walk backwards when working

with the pole hedge trimmer.

- Always stop the engine before cleaning or servicing the machine. Also, refrain

from replacing parts before the engine has been stopped.

- Do not operate the pole hedge trimmer if the cutting unit is damaged or worn.

3 m

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita EN4951SH Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Makita EN4951SH

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info