Bedienungsanleitung Makita EW120R (Seite 31 von 152) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

599905

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

8. EASY TROUBLESHOOTING

4. WHEN ENGINE DOES NOT START :

Perform the following checks before you take the pump to

your Makita dealer. If you still have trouble after completing

the checks, take the pump to your nearest Makita dealer.

(1) Is there a strong spark across the electrode ?

Is the stop switch at position “ I ” (ON)?

Remove and inspect the spark plug.

If the electrode is fouled, clean or replace it with new

one.

Remove the spark plug and connect it to the plug cap.

Pull the starter handle while grounding spark plug against

engine body. Try with a new spark plug if the spark is

weak or there is no spark.

The ignition system is faulty if there is no spark with a

new spark plug.

Wipe out spilled fuel carefully before testing.

Place spark plug as far away from spark plug

hole as possible.

Do not hold spark plug by hand while pulling

recoil starter.

WARNING

NOTE

The engine with oil sensor will stop automatically when

the oil level falls below the prescribed limit.

Unless the oil level is raised above the prescribed limit,

the engine will stop immediately after starting.

(3) Is the spark plug wet with gasoline?

Is the fuel cock opened? (Except EW120R)

Choke (close choke lever) and pull the starter handle five

or six times. Remove the plug and check if its electrode

is wet. If the electrode is wet, fuel is well supplied to your

engine.

When the electrode is dry, check where the fuel stops.

(Check the fuel intake of the carburetor and fuel filter

intake.)

(EW120R)

(Check the fuel intake of the carburetor.) (Except EW120R)

In case the engine does not start with well supplied fuel,

try using fresh fuel.

Pull the starter handle slowly and check if resistance is

felt. If little force is required to pull the starter handle,

check if the spark plug is tightened firmly. If the spark

plug is loose, tighten it.

(2) Is there enough compression?

1. FUNCTION OF OIL SENSOR

The engine will stop automatically when the oil level falls

below the safety limit. The engine cannot be started unless

the level is raised above the prescribed limit.

(See Fig.8

2. RESTARTING

(1) Fill the crankcase with oil up to the proper level.

(2) As for restarting and operating the engine, refer to

section “4. OPERATING YOUR PUMP” on page 7.

Check the wire connector from the engine. It must be

connected securely to the wire from oil sensor.

When selecting the engine oil, refer to page 6 for the

recommended oil.

7. OIL SENSOR INSTRUCTIONS

(OPTIONAL)

1. PUMP DOES NOT RUN .

Engine dose not start.

(See 8.-4 “4. WHEN ENGINE DOES NOT START

”)

Sticking of impeller (Disassemble and clean.)

2. PUMPING VOLUME IS SMALL.

Sucking air at suction side.

(Check piping at suction side.)

Drop off engine output

(Consult your nearest dealer.)

Breakage of mechanical seal.

(Consult your nearest dealer.)

High suction lift (Lower.)

Suction hose is too long or thin.

(Use a thick hose in minimum length.)

Leak of water from water passage. (Stop leaking.)

Clogging of foreign substance in impeller.

(Disassemble and clean.)

Wear of impeller.

Strainer is clogged. (Clean.)

Engine speed is too low. (Consult your nearest dealer.)

3. PUMP DOES NOT SELFPRIME.

Suction of air at suction side.

(Check piping at suction side.)

Insufficient priming water inside pump casing

(Prime fully.)

Imperfect tightening of drain plug.

(Tighten the plugs completely.)

Engine speed is too low.

(Consult your nearest dealer.)

Sucking air from mechanical seal.

(Consult your nearest dealer.)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita EW120R Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info