Bedienungsanleitung Makita HTR 4901 (Seite 8 von 100) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

448548

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

FUELS/REFUELING

Fuel and oil mixture

፴፧ The engine of the hedge Trimmer is a high-efficiency two-stroke engine.

It is run with a mixture of fuel and two-stroke engine oil. The engine is

designed for unleaded regular fuel with a min. -octane value of 91 ROZ.

In case no such fuel is available, you can use fuel with a higher octane value.

This will not damage the engine, but may cause poor operating behaviour.

A similar situation will arise from the use of leaded fuel.

To obtain optimum engine operation and to protect your health and the

environment, only unleaded fuel should be used!

፴፧ For lubricating the engine use a two-stroke engine oil (quality grade:TSC-3),

which is added to the fuel.

The engine has been designed for use with MAKITA two-stroke engine oil

and a mixture ratio of 50:1 only to protect the environment. In addition, a

long service life and a reliable operation with a minumum emission of exhaust

gases is guaranteed. It is absolutely essential to observe a mixture ratio of

50:1 (MAKITA 2-stroke engine oil), otherwise the reliable function of the

Hedge Trimmer cannot be guaranteed.

፴፧ The correct mixture ratio:

Gasoline : Makita genuine two-stroke engine oil = 50 : 1 or

Gasoline : Other manufacturer’s two-stroke engine oil = 25 : 1

recommended

NOTE: For preparing the fuel-oil mixture, first mix the entire oil quantity with

half of the fuel required. In an approved can which meets of exceeds

all local code standards, then add the remaining fuel.

Thoroughly shake the mixture before filling it into the Hedge Trimmer’s

tank.

It is not wise to add more engine oil than specified to ensure safe

operation. It will only result in a higher production of combustion

residues which will pollute the environment and clog the exhaust

channel in the cylinder as well as the muffler. In addition, the fuel

consumption will rise and the performance will decrease.

Handling petroleum products

Utmost care is required when handling fuel. Fuel may contain substances

similar to solvents. Refuel either in a well ventilated area or outdoors. Do not

inhale fuel vapors, avoid any contact of fuel or oil with your skin.

If your skin comes in contact with these substances repeatedly and for an

extended period of time, it will desiccate.

Variouse skin diseases may result. In addition, allergic reactions are known to

occur.

Eyes can be irritated by contact with oil, fuel etc.

If oil, fuel, etc., comes into your eyes, immediately wash them with clear water.

If your eyes are still irritated, see a doctor immediately!

Observe the Safety Instructions on page 4.

Gasoline 50:1

1000 mL (1 L)

5000 mL (5 L)

10000 mL (10 L)

20 mL

100 mL

200 mL

ᯛ

ᯛᯛ

ᯛ

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita HTR 4901 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info