296199
17
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
33 34
If you do not operate the camera for 60 seconds, the camera will automatically enter
the sleep mode in order to save battery power. In the sleep mode the camera will not
automatically wind the film to the 1st frame, even if the custom setting is enabled (C-
31 on page 94). In this case, press the shutter release button halfway down to feed
the film to the 1st frame position.
8. Close the back cover.
Push in the upper part of the back cover firmly
to close it.
After attaching the magazine onto the camera
body, pull out the dark slide and press the
shutter button halfway; this will feed the film
automatically to frame No. 1.
Place the dark slide in the magazine's rear
storage pocket.
7. Insert the loaded film insert into
the magazine.
While squeezing the center latches together,
place the film insert, with the feed spool on top,
in the magazine and with pressure on the left
and right blocks push it into proper position.
(You will hear a click).
6. Attach the leader paper of the
film to the empty spool.
As shown in the figure left, gently insert the
leader paper tip into the groove on the empty
spool that is on the “SPL” side, and turn the
spool one or two turns to wrap the leader tape
around it. It is not necessary to finely adjust the
position of the film’s starting edge manually as
the film will be wound into the correct position
automatically.
Turn the spool tight so that the film does not
sag.
When the film is not wound properly, the “- - ” mark appears in the LCD.
Do not wrap too much leader paper around the empty spool. Otherwise the film sec-
tion may be exposed to light.
To prevent accidental film fogging, do not pull out the leader paper too far or load/
unload film under direct sunlight.
Make sure that the film insert is properly fixed. When one or both white latches are
out of position, press the projecting portion or until it clicks.
6-exposure film
If you take more than 8 pictures when using a 6-exposure film, the shutter
blades may be damaged by the leader paper at the film end or by the film tape.
Follow the procedure below.
Photograph in the same way as with 120 film. Eight exposures can be taken.
After taking the 8th exposure, insert the dark slide in the magazine.
Then hold down the emergency film wind button and half-press the shutter re-
lease button.
1. The camera can be set to wind the film to the 1st frame position
automatically after the back cover is closed.
Custom settings (C-32 on page 94)
2. Normally, after the rear cover is closed the shutter cannot be released
without any film in the camera. However, the camera can be set to allow
you to release the shutter without any film.
Custom settings (C-31 on page 94)
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Mamiya 645 af d ii wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info