753641
23
Zoom out
Zoom in
Vorherige Seite
1/50
Nächste Seite
23
NOTE: This is thermostatic remote control. The remote should be in the same room as fireplace and placed
on a flat surface. It must be placed away from the fire so the hot air will not blow on it and affect
thermostatic reading.
The communication frequency between the fire and remote has already been set
up. If you cannot use the remote with the fire, please follow instructions
Step.3b.34 to initiate this connection in point.
Standby for Remote Handset
3b.1 The screen shown to the right is when the remote handset is in
standby condition.
Turn on/off
3b.2 Press to turn on the flame effect, turn off flame effect and heater
when in normal mode.
3b.3 Press to turn on/off the flame effect under daily and weekly timer
mode.
Flame Effect
3b.4 Press to enter the flame effect adjustment screen.
3b.5 Press the ‘←’ and ‘→’ button to select the 3 kinds of flame effect.
3b.6 Press the ‘+’ and ‘-’ button to select the 5 brightness of flame effect and OFF
settings.
Normal Mode
3b.10 Normal control mode is factory set. If it is not, then press button until
the logo shows up at the upper right corner of the screen.
3b.11 Press the ‘+’ and ‘-’ button to adjust the setting temperature from 17 to
25 by 2 intervals.
3b.12 Press button to turn on/off heat, ONOFF will show at the
lower of the screen.
NOTE: It is normal for the fan heater to stop running for periods of time. This
happens because the room temperature is at or above the temperature set on the
remote control. The heater indicator will be turned off after 10s if you have the
flame ON. The heater indicator will stay ON if you use the heating function only.
Count Down Timer
NOTE: This setting is only for normal mode. It allows the appliance to go into standby
after a set period of time.
3b.13 Press to cycle through the settings from Off and 0.5 hours to 9 hours.
The timer logo and time will show on the screen. The heater must be in the
ON position.
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Manor House Dex wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info