EnglishDeutsch Page 43
O
21
Programming the control unit
• As soon as the control unit is switched on, it runs a self-test, recognizable through the
indicators 1 - 8 and the operator lighting which glow for approx. 1 second.
Afterwards the control unit is in the operating state (indicator 8 glows).
• If button P is pressed for longer than 2 seconds, the control unit changes to the
programming mode.
• By repressing button P the programming menus necessary for programming the basic
operator settings are selected in turn.
• If a programming menu is skipped, the setting remains unchanged.
• Using the
or
buttons, changes can be made in the corresponding programming
menu which can then be stored by pressing button P.
• If the control unit is in the programming mode and 30 seconds elapse without any of the
3 programming buttons having been pressed, the programming process is aborted and the
control unit returns to its operating state (error message 7, see pt. 27).
• On misprogramming there is no need to reset because all the stored settings can be
reprogrammed.
LED OFF
LED glows
LED flashes
LED flashes rapidly
O
22
Programming the electronic control unit:
A Indicator programme external photocell
B Indicator programme 'OPEN' travel limit
C Indicator programme automatic timer
D Indicator programme 'CLOSE' travel limit
E Indicator programme light phase
F Indicator programme power limit
(indicators 6 and 2 flashing: 'OPEN' power limit)
(indicators 6 and 4 flashing: 'CLOSE' power limit)
G Indicator programme remote control
I Programming button
J Programming button
K Programming button P (programming mode, menu selection/store programming)
To display the electronic control unit fault message:
In the case of a fault message, the cause of the fault can be displayed, see pt. 27.
K Programming button P to display fault (press briefly)
1 - 8 Display of fault numbers (flash erratically)
for example: numbers 8 and 2 flash together:
8 + 2 = fault number 10 (see pt. 27)
Seite 22
Programmiertabelle Ebene 5
Antriebsbeleuchtung/Signalleuchten
Der Antrieb hat die Möglichkeit des Anschlusses einer externen Signalleuchte, wenn an der
Steuerung der Relais-Nachrüstsatz 'Torfunktion AUF-ZU+Licht' für Normantriebe im Gehäuse
(Art-Nr: 152137) angeschlossen wird und der automatische Zulauf aktiviert ist.
Dieser Ausgang kann so programmiert werden, daß die Signalleuchten blinken oder leuchten.
