24 Manual for installation and operation, Comfort 211 GB (#72752)
8. Initial operation
8.5 Express programming
8.5.1 General notes on express programming
The programming button P can be pressed using the
programming pin (A), which is included in the
package.
The controls are programmed using the plus (+),
minus (-) and P buttons.
If no buttons are pressed within 120 seconds while in
programming mode, the controls revert to operating
mode.
A corresponding message is displayed.
8.5.2 / 1
Reference:
The messages are explained in
Section 10.
A
8.5.2 Programming buttons
Preconditions
The following conditions must be assured before
express programming can commence:
- The door must be in the CLOSED end position.
- The carriage must be connected up.
Express programming
The basic functions of the operator system are set
during the express programming procedure.
- Door OPEN position
- Door CLOSED position
- Remote control
The programming procedure is a consecutive process.
It is essential that this procedure be carried out.
After express programming has been completed and a
learning run has been carried out to set the automatic
cut-out at the OPEN and CLOSED door positions, the
operator system is ready for operation.
Advice:
For proper initial operation of the
operator system, the express
programming procedure must be
carried out.
This applies for the initial operation and
after resetting.
Advice:
When programming the OPEN and
CLOSED door positions, the reference
point must be passed.
• Carry out the express programming according to the
following procedure.
Legend:
LED off
LED on
LED flashes slowly
LED pulses
LED flashes quickly
Factory default setting
Not possible
–
