English Page 10
D. Installation
Mount the lintel joining plate
• To protect the pull element, which is integrated in the boom (chain or toothed
drive belt), against unauthorized and forced dismantling from the outside
(break-in), push the red securing sleeve (D) over screw (E) (fig. D.8).
• Then connect the lintel joining plate (A) and the boom end piece (B) with bolt
(C) (fig. D.9).
Unlock the carriage
• Push the red release pin (B) to the stop into the red opening of the carriage
(fig. D.10).
• Pull the cable (A) (fig. D.12).
• The carriage is now unlocked and can be slid freely in the boom and
connected to the door.
• For further information regarding the carriage please look up point 13.
Garage door operator with up-and-over door
• Screw the lintel joining plate (A) together with the boom to the top frame,
lintel or ceiling, so that the upper edge of the door leaf lies approx. 10 mm
below the downward edge of the horizontal boom - measured at the highest
point of the opening course (see as well point 3).
• Put the operator unit onto a trestle or another suitable object until it is fixed
later to the ceiling.
8
7
6
GB
English Page 83
L. Initial operation and maintenance
Initial operation
Attention!
Power operated windows, doors and gates for industrial use have
to be checked before initial operation or if necessary, but at least
once a year by a specialist (with written documentation)!
Maintenance instructions
Please observe the following points in order to guarantee a faultless function:
• Check the separate counterbalance of the door regularly.
The door has to be moved easily by hand if the operator is disengaged.
• The door system, especially cables, springs and fixing components have to be
checked regularly for signs of wear, damages or for faulty balance.
• The function of automatic cut-out 'open' and 'close' has to be checked
regularly.
• Test monthly, if the operator reverses when the door meets an obstacle of
50 mm that is lying on the floor.
Correct, if necessary, the adjustment of the reversion function and test it
again, because a wrong adjustment could be dangerous.
Caution!
The door system must not be used during repair or adjustment
works. A fault in the system or a wrongly balanced door may
cause injuries.
