4. Important Safety Advice
English / Page 7
This control unit may only be connected and put into operation by qualified and
suitably trained specialist personnel. For the purpose of this description qualified
and suitably trained specialist personnel are persons who are adequately instructed
or supervised by qualified electricians and are thus in a position to recognize
the hazards that electricity can cause. Moreover, they must hold qualifications
consistent with the work being carried out. This presupposes in particular
• knowledge of applicable electro-technological regulations,
• training in the use and maintenance of adequate safety equipment,
• first aid training.
Attention!
Before carrying out any cabling work, it is essential to
disconnect the control unit from the mains supply.
• Observe local safety regulations!
• Always lay mains cable and control cable separately.
Control voltage 24 V DC.
Attention!
Before putting the control unit into operation, it is essential to
ensure, that there are no persons or objects within the door's
aeria of operation, since a number of settings set the door in
motion!
• All available emergency command devices must be tested prior to initial
operation.
• The door operator must be installed with the door closed!
• After installation and initial operation, those persons or their representatives
responsible for operating the door system must be shown how the door
system works!
• No cables should be fed into the top of the control unit!
• For technical reasons, the first time the control unit is switched on and after
actuating the control elements, the door travels to its end position OPEN.