English / Page 24
6. Display Functions and Programming Possibilities
General advice for programming the control unit
Indication of reference point
The operator is above the reference point:
• LED 5 flashing
The operator is below the reference point:
• LED 5 is on.
Advice:
The control unit can only be programmed if a valid
reference point is set. Therefore please perform once a
power-operated door travel to OPEN and CLOSE position
before programming.
Advice for programming:
If the control unit is in programming mode and neither
programming button (h ,g, j) is pressed during 120
sec., the programming is cancelled and the control unit
changes again to the operation mode.
