9
3.5.2 Dynamic 3-201 - 3-208
Note / Advice
For setting the cams you need a socket head screwdriver with handle,
width across flats 2,5mm.
3.5.2.1 Setting of end position DOOR CLOSED
• Move the door manually into the mechanical end position DOOR CLOSED.
• Open the case lid of the door operator.
• Loosen the locking device (grub screw (J)) of the switch cam (A).
• Adjust the switch cam A so that the limit switch DOOR CLOSED (G) is operated as
shown in illustration D.1 (position H).
• Fix the switch cam (A) again by tightening the grub screw (J).
• If necessary, adjust the position of the door DOOR CLOSED with the screw for fine
adjustment (K) at the switch cam.
Fig. D/1: Setting of end position DOOR CLOSED
3. Initial operation of the Control 22 / 23 control unit
ABCDEF
A
H
G
J
K
