GB
O
2
- Boom extrusion
• Insert ball (A) into bolt (B).
• Push bowden cable end sleeve (C) into the thrust bearing (D) on the carriage.
- Boom extrusion
• Insert ball (A) into metal lever (B).
• Push bowden cable end sleeve (C) into the thrust bearing (D) on the carriage.
- Boom extrusion
• Pull cord (E) downward, until the movable slide bar (B) is situated before the stop (F) in the
carriage.
• Hold cord and insert ball (A) into the slide bar according to illustration.
• Release cord and insert bowden cable terminal sleeve (C) into the outer bearing (D) of
carriage.
Guide bowden cable terminal sleeve from below into outer bearing and then move it
upwards.
-Boom extrusion
• Insert ball (A) on Bowden cable into separator slide (B) on the carriage.
• Push Bowden cable end sleeve (C) into thrust bearing (D) on the carriage.
Door type: up-and-over door,
Special 311 emergenev release, item no.: 152 115
Run the bowden cable from the carriage to the door link bracket (A) via the shortest possible
route. Insert adjusting screw (B) into the door link bracket as illustrated and tighten.
Replace inside handle (C) and pull the wire cable through the handle,
Push screw nipple (D) onto the wire cable underneath the inside handle and clamp in place.
If the supplied inside handle cannot be used. drill through the existing handle as
shown in the illustration.
Secure the bowden cable with the enclosed fastenings (E & F). Select the shortest possible
distance from the carriage to the door lock.
Important:
Set the bowden cable with the adjusting screw and screw nipple free from play.
O
1a
O
1b
O
1c
O
1d
